MAINS SUPPLY
English
1.Check if the mains supply, as shown on the type plate inside the battery compartment, corresponds to your local mains supply.
2.If your set is equipped with:
•a voltage selector - found on the back of the set
•a frequency selector - inside the battery compartment adjust these selectors to match with your local mains supply and frequency.
3.Connect the mains plug into the wall socket. The mains supply is now switched on and the numbers on the display will start to flash. You will need to set the correct time.
4.To disconnect the set from the mains supply completely, withdraw the mains plug from the wall socket.
Standby power consumption: | 3W |
POWER BREAKDOWN BACKUP
When a power failure occurs the complete clock radio will be switched off. When the mains supply returns, the numbers on the display will start to flash and you will need to reset the correct time on the clock.
To retain the clock time and the set alarm time in the event of an AC mains failure or disconnection, insert a 9 volt battery, type 6F22 (not supplied) into the battery compartment: this will act as a mains backup. However, the time will not be illuminated on the clock display. Operation of the alarm and radio are also excluded. For clarity, the battery backup is used to retain the clock and alarm time only. As soon as the mains supply returns, the display will indicate the correct time.
1.Insert the battery into the battery compartment.
2.Connect the mains plug to the wall socket.
• Replace the battery once a year, or as often as necessary.
6