CLOCK | ALARM |
Clock display
The time is displayed using the
Adjusting the time
1.Adjust the clock control to the TIME SET position.
2.Press and hold down the 4,7 buttons to set and adjust both the hours and the minutes.
–With your finger held down on 7, the time will increase rapidly and continuously from minutes to hours. Release 7 when you reach the approximate time setting.
–Pressing 4 will allow you to adjust the time slowly back minute by minute.
3.Release the 7 or 4 buttons when you have reached the correct setting.
4.To safeguard the clock time from being accidentally adjusted, turn the clock control to the RUN position.
SETTING THE ALARM
General
If you wish to use the alarm, then you should first set the alarm time. Two different alarm times are possible. This can be useful when, for example, you need to be awakened at a different time during the week and at the weekend. There is also the choice of two modes for waking you up: by buzzer or radio. The display also indicates whether you have switched on the alarm (s), and these indicators will light up respectively next to ALARM 1 and ALARM 2 on the display.
ALARM ON
1.Adjust the clock control to the ALARM 1 or ALARM 2 position.
2.Press and hold down the 4, 7 buttons to set and adjust both the hours and minutes.
–With your finger held down on 7, the time will increase rapidly and continuously from minutes to hours. Release 7 when you reach the approximate time setting.
–Pressing 4 will allow you to adjust the time slowly back minute by minute.
3.Release the 7 or 4 buttons when you have reached the correct setting.
4.Adjust the clock control to the RUN position to return to clock time display.
–To review your set alarm time, adjust the clock control to the respective ALARM 1 or ALARM 2 position.
5.To select the alarm mode you wish to be awoken by, set the respective ALARM 1or ALARM 2 switch to RAD or BUZ.
–If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you.
–The 2 buzzers are at a set volume and cannot be adjusted. BUZ on ALARM 1 is a low tone buzzer while BUZ on ALARM 2 is high tone.
ALARM OFF
You can switch off the alarm in three ways: Unless you choose to cancel the alarm completely, the ALARM RESET option will be automatically selected after 59 minutes from the time your alarm first goes off.
Alarm reset
If you want the alarm mode to be stopped immediately, but also wish to repeat the alarm call at the same time for the following day:
• Press ALARM RESET during the alarm call.
Repeat alarm
This will repeat your alarm call at 7 minutes intervals.
•Press SLUMBER OFF/REPEAT ALARM.
•Press SLUMBER OFF/REPEAT ALARM again during the next call if you wish to repeat the alarm call.
•If, however, you do not press SLUMBER
OFF/REPEAT ALARM again, the alarm will sound for 59 minutes before turning itself off. Your alarm time setting will then automatically enter the ALARM RESET mode to sound at the same time next day.
English
5