Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| ||
TROUBLESHOOTING & REPAIR | ||
Observe Safety Guidelines |
| TROUBLESHOOTING GUIDE |
detailed in the beginning of this manual. |
| |
|
|
|
PROBLEMS | POSSIBLE AREAS OF | RECOMMENDED |
(SYMPTOMS) | MISADJUSTMENT(S) | COURSE OF ACTION |
|
|
|
| FUNCTION PROBLEMS |
|
The machine will not shut off when | 1. Make sure the | 1. Check the Input Power switch |
the power switch is put in the OFF | input lines are connected cor- | (S1) and the associated leads. |
position. | rectly to the | See Wiring Diagram. |
|
| 2. Perform the Input Contactor |
|
| Test. |
|
|
|
The Arc Control switch (S5) has no | 1. Make sure the correct process | 1. Check the Arc Control switch |
effect in CV (FCAW/GMAW) mode | and gas are being used. | (S5) for proper operation. |
when welding with the short circuit |
| 2. Check the welding Mode switch |
transfer process. |
| |
| (S4), the microswitches, and the | |
|
| |
|
| associated wiring. |
|
| 3. Check to make sure the output |
|
| choke control coil is not “open” |
|
| or grounded. See Wiring |
|
| Diagram. |
|
| 4. Check resistor R1. Normal |
|
| resistance is 15 ohms. |
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con- tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
IDEALARC
LINCOLN ®
ELECTRIC