Friedrich SQ10N10, SQ08N10, SQ05N10, SQ06N10, EQ08N11 manual Kuhl Q Control Panel Operation

Kuhl Q Control Panel Operation

Let’s check out how to control your air conditioner. On the control panel, just above the POWER , is a liquid crystal display (LCD). All of the control panel function buttons and mode icons can be viewed in Figure 6.

Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch will automatically dim to 20% intensity after 15 seconds of inactivity. The remote control can also be used to turn power ON / OFF (See Remote Control).

Display – The display is a high ef¿ciency LCD with a built-in white backlight. The backlight has an automatic two (2) step dim function. After 15 seconds of inactivity, the display dims to 20% intensity. After an additional 120 seconds, the display switches off. Touching any button automatically changes the display to full brightness.

There are three control push buttons on each side of the display.

Figure 2

SYSTEM:

Cycles between

HEAT, COOL or

FAN ONLY

FAN MODE:

Sets fan to either:

-Cycle automatically

-Run continuously

FAN SPEED: Sets fan speed:

LOW, MED, HIGH or AUTO

(as equipped)

ON / OFF: Turns unit on/off

		FAN		CONTROL
COOL	HEAT	ONLY		LOCKED			WI-FI
							OPERATING (if equipped)
							TEMPERATURE:
							Increment UP
			88				WAIT
							COMPRESSOR
	AUTO FAN					F	3 MINUTES
						C	TIME DELAY
	CONTINUOUS					AM	TEMPERATURE:
						PM
				SET POINT		ON OFF	Increment DOWN
					SCHEDULE
				ROOM TEMP			SCHEDULE ON
				CHECK $MART
	AUTO SPEED
				FILTER
							TIMER / SCHEDULE
							Turns ON or OFF
							TIMER ON

	IR WINDOW:
	Do not block
FILTER	2 DIGIT DISPLAY
Check / Clean	Shows Setting for:
AUTO SPEED	- Set Point (Temperature)
	- Room Temperature
Automatically selects	- Clock (AM/PM)

best fan cooling or heating speed

FAN SPEED	SMART OPERATING
Selected fan speed	(see page 10)

8