Craftsman 919.7247 Maintenance, Customer Responsibilities, To Check Safety Valve, To Drain Tank

Page 16

MAINTENANCE

Customer Responsibilities

 

Before

Daily or

Every

Every

 

 

each

after

Yearly

 

40

100

 

each

 

use

use

hours

hours

 

 

 

 

Check Safety Valve

 

 

 

 

Drain Tank

 

 

 

 

Air Filter

 

 

●(1)

 

Air compressor pump intake

 

 

 

 

and exhaust valves

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1- more frequent in dusty or humid conditions

 

 

 

 

 

 

 

 

 

Unit cycles automatically when

power is on. When performing maintenance, you may be exposed to voltage sources, compressed air, or moving parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect power source from the compressor and bleed off all air pressure.

To ensure efficient operation and longer life of the air compressor outfit, a routine maintenance schedule should be prepared and followed. The following routine maintenance schedule is geared to an outfit in a normal working environment operating on a daily basis. If necessary, the schedule should be modified to suit the conditions under which your compressor is used. The modifications will depend upon the hours of operation and the working environment. Compressor outfits in an extremely dirty and/or hostile environment will require a greater frequency of all maintenance checks.

To Check Safety Valve

If the safety valve does not work

properly, over-pressurization may occur, causing air tank rupture or an explosion.

1.Before starting compressor, pull the ring on the safety valve to make sure that the safety valve operates freely. If the valve is stuck or does not operate smoothly, it must be replaced with the same type of valve.

To Drain Tank

1.Set the On/Auto/Off lever to “OFF”.

2.Pull the regulator knob out and turn clockwise to set the outlet pressure to zero.

3.Remove the air tool or accessory.

4.Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately 20 psi. Release safety valve ring.

5.Drain water from air tank by opening drain valve (counter- clockwise) on bottom of tank.

NOTE: See “Operation” section for the location of controls.

Water will condense in the air

tank. If not drained, water will corrode and weaken the air tank

D24563

16- ENG

Image 16
Contents AIR Compressor Sold by Sears Canada, Inc. Toronto, Ont. M5B 2B8Table of Contents Safety Guidelines Definitions Specification ChartImportant Safety Instructions Risk of Explosion or Fire HOW to Prevent ITWhat can Happen Risk of Bursting Risk from Flying ObjectsRisk of Electrical Shock What can Happen HOW to Prevent ITRisk to Breathing Risk from Moving Parts Risk of BurnsRisk of Falling Risk of Unsafe Operation Accessories AccessoriesGlossary Assembly Duty CycleInstallation Location of the Air CompressorRisk of Electrical Improper Grounding can Result in Electrical ShockExtension Cords Voltage and Circuit ProtectionOperation Description of OperationOutlet Pressure Gauge The outlet Tank Pressure Gauge The tankHow to Use Your Unit Break-in ProcedureBefore Each Start-Up DrainMaintenance To Check Safety ValveCustomer Responsibilities To Drain TankAir Filter Inspection and Replacement Air Compressor Pump Intake and Exhaust ValvesMotor Air FilterService and Adjustments To Replace or Clean Check ValveRing Nut Outlet Tube Pressure Relief Check ValveRegulator Tank Outlet Pressure PressureGauge Quick Connect To Replace RegulatorRegulator Arrow Storage Troubleshooting Problem Cause CorrectionPressure reading Check wiring connection Pour Placer UNE Commande Table DES MatièresGarantie Complète DE UN AN SUR LES Compresseurs D’AIR Sears Canada, Inc., Toronto, Ont. M5B 2B8Mesures DE Sécurité Définitions Tableau DES SpécificationsConsignes DE Sécurité Importantes Risque Risque D’EXPLOSION OU D’INCENDIEPrévention Risque D’ÉCLATEMENT Risque DE Projection D’OBJETSRisque DE Choc Électrique Risque PAR InhalationRisque DE Brûlures Risque Relié AUX Pièces MobilesRisque DE Chute Risque PréventionRisque Dune Utilisation Dangereuse Accessoires AccessoiresLexique Cycle DE Service AssemblageDirectives DE Mise À LA Terre Emplacement du compresseur dairRisque DE Chocs Rallonges Protection contre la surtension et protection du circuitFamiliarisez-vous avec votre compresseur dair UtilisationDescription du fonctionnement Utilisation de lappareil Avant le démarrageArrêt de lappareil Procédures de rodageAvant chaque mise en marche Mise en marcheEntretien Responsabilités du clientVérification de la soupape de sûreté Vidange du réservoirMoteur Filtre à air Inspection et remplacementFiltre à air Remplacement ou nettoyage de la soupape de retenue Entretien ET RéglagesRemplacement du régulateur Régulateur FlècheRangement Dépannage Problème Cause CorrectionSerrer Peut éclater ou exploserConsidérée normale Pas Surcharges déclenché 54- FR 55- FR D24563 Get it fixed, at your home or ours