Outlet
Pressure
Gauge
Regulator Quick
Connect
4.Remove the regulator.
5.Apply pipe sealant tape to the nipple.
Niple
6.Assemble the regulator and orient as shown.
Regulator
NOTE: Arrow indicates flow of air. Make sure it is pointing in the direction of air flow.
7.Reapply pipe sealant to outlet pressure gauge and quick connect.
Regulator
Arrow
8.Reassemble outlet pressure gauge and quick connect. Orient outlet pressure gauge to read correctly. Tighten quick connect with wrench.
STORAGE
Before you store the air compressor, make sure you do the following:
1.Review the Maintenance section on the preceding pages and per- form scheduled maintenance as necessary.
2.Set the On/Auto/Off lever to "Off" and unplug unit.
3.Turn the regulator counterclock- wise and set the outlet pressure to zero.
4.Remove the air tool or accessory.
5.Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately 20 psi. Release safety valve ring.
6.Drain water from air tank by open- ing drain valve on bottom of tank.
Risk of Bursting. Water will condense
in the air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture.
7.After the water has been drained, close drain valve by turning clock- wise.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.
8.Protect the electrical cord and air hose from damage (such as being stepped on or run over). Wind them loosely around the com- pressor handle.
9.Store the air compressor in a clean and dry location.
A17883 | 18 - ENG |