SM 2610957105
Assembly and adjustments
Install the fence (Fig. 7)
1.Raise the clamp (1) on the fence assembly to the up position.
2.Place the fence on the table so that the clamp is at the front of the table.
3.Lower the fence clamp to lock the fence in position on the table. Rotate clamp to adjust tightness.
To move the fence, raise the clamp and slide the fence to the desired location. Lower the clamp to lock the fence in position.
FIG. 7 |
1 |
Mount the band saw to a work surface (Fig. 8)
Secure the saw to a suitable work surface by inserting the appropriate mounting hardware through the four pre- drilled holes (2) in the base of the saw.
Adjustments
!Before adjusting the band saw, turn WARNING off the saw, remove the safety key,
and unplug the power cord from the electrical outlet. The power cord must remain unplugged whenever you are working on the saw.
Table tilt adjustment (Fig. 9)
The table tilts from 0° to 45° to the right.
1.Turn the table tilt lock knob (3) counterclockwise.
2.Turn the table tilt adjustment knob (4) until the pointer is at the desired angle on the table tilt gauge (5).
3.Tighten the table lock knob (3) to secure the table.
Connect to a dust collection system (Fig. 10)
A 1 1/2" (3.8 cm) dust port (6) is located on the motor side of the band saw. This port can be connected to a dust collection system directly by connecting the pickup end of the dust collection hose to the dust port.
FIG. 8
2
2
FIG. 9
4
5 3
FIG. 10
6
10.