REMOVING CHUCK
Rotate the clutch ring to the drill bit
symbol “
”. Open the chuck all the way, remove
a 3/8" hex key wrench and close jaws on flats of wrench. Strike long arm of wrench sharply counterclockwise, remove wrench and unthread chuck from spindle (Fig. 2).
INSTALLING CHUCK
Always keep the spindle threads, the threads of the chuck and securing screw free of
debris. To install a chuck, reverse “removing the chuck” procedure.
RELEASING AND INSERTING BATTERY PACK
Release battery pack from tool by pressing on both sides of the battery release tabs and pull downwards. To insert battery, align
battery and slide battery pack into tool until it locks into position. Do not force.
CHARGING BATTERY PACK (1 HOUR CHARGER)
Plug charger cord into your standard power outlet, then insert battery pack into charger.The charger’s green indicator will begin to “BLINK”. This indicates that the battery is receiving a fast charge. Fast- charging will automatically stop when the battery pack is fully charged.
When the indicator light stops “BLINKING” (and becomes a steady green light) fast charging is complete.
When you begin the charging process of the battery pack, a steady green light could also
mean the battery pack is too hot or too cold.
The purpose of the light is to indicate that the battery pack is
When the battery pack is fully charged, unplug the charger (unless you're charging another battery pack) and slip the battery pack back into the tool handle (Fig.3).
FIG. 3
BATTERY PACK
CHARGER
INDICATOR
LIGHT