Sterling Plumbing 822.00247.00 specifications Basic Menus and Setup of Controller

3-4 Setup

This section provides the procedures for configuring your 1-pump, 9-station controller.

Configuration of your controller includes setting the number of stations and pumps, setting variables such as convey time and blow-back intervals. We recommend that you carry out these procedures in the order given here.

Note: Before carrying out these procedures, install all equipment as described in this section and in the Conveying Systems manual.

Basic Menus and Setup of Controller

Once power has been applied to a properly installed system, turn the disconnect switch to the ON position. The controller will display the title screen (Shown below) after the initial Mitsubishi controller serial number screen has been displayed.

Figure 1: Title Screen

The operator will then have to press the F6 key to enter the Main Menu (Figure 2).

Figure 2: Main Menu Screen

The Main Menu will provide access to the following controller functions and features:

•Turning the system On and Off

•Viewing the status of the system

•Setting station features

•Setting pump features

•Setting system features

Activating and Deactivating the System

To activate or deactivate the system, press the F1 key on the controller keypad.

Note: The system can also be turned On and Off by pressing F1 in additional screens which will be mentioned later in this manual.

1 –Pump 9-Station Controller Chapter 3: Installation 17 of 38