Sterling Plumbing 822.00247.00 specifications Initial Pump Setup Screen

Page 24

Pump Setup

To set the pump settings and features of your conveying system, press the F5 key on the controller keypad while in the Main Menu screen. The initial (of three) Pump Setup screen will be shown (below):

Figure 10: Initial Pump Setup Screen

This screen will allow you to set the following features:

•FC ENABLE F2 – Pressing F2 allows you to enable or disable the filter cleaning feature.

•FC TYPE F5- This feature allows you to toggle between blowback and implosion cleaning (Press F5). This setting must match the equipment that was installed in your system.

•CNVYS/CLEAN – This is the number of convey cycles allowed between filter cleanings. This value can be set between 1 and 99.

Once the values have been entered for the settings listed above, the operator can choose to do the following:

•Turn the pump On or Off (Press F1 while in this screen)

•Enter additional values for this pump in the second setup screen (Press F3).

•Return to the Main Menu (Press F6).

1 –Pump 9-Station Controller

Chapter 3: Installation

23 of 38

Image 24

Contents SCC 1-Pump 9-Station Controller Parts and Service Department Shipping Information Unpacking and InspectionEvent of Shipping Damage If the Shipment is Not CompleteWarranty Returns ReturnsCredit Returns Table of Contents Configurable Settings Safety How to Use This ManualSafety Symbols Used in this Manual Controller Safety Tags Description Wear Safety Glasses and Work Gloves Responsibility General ResponsibilityMaintenance Responsibility Reporting a Safety DefectOperator Responsibility Functional Description Models Covered in This ManualGeneral Description Standard Features Mechanical FeaturesElectrical Features Controller FeaturesOptional Features Safety Devices and InterlocksSafety Circuit Standards Fail Safe OperationSafety Device Lock-Outs Installation Making Control Panel Power Drop Wiring ConnectionsUncrating Mounting the Control PanelConnecting the Control Panel to Vacuum Hoppers Connecting the Control Panel to the Pump PackageSetup Basic Menus and Setup of ControllerActivating and Deactivating the System Viewing System Status Name DescriptionStation Setup Initial Station Setup ScreenEntering Values Into Controller Fields Controller KeypadSecond Station Setup Screen Third Station Setup Screen Pump Setup Initial Pump Setup ScreenSecond Pump Setup Screen Third Pump Setup Screen System Setup Initial System Setup ScreenSecond System Setup Screen Third System Setup ScreenAlarms OperationOverview Starting and Stopping the SystemPump Fault General FaultAll Faults Filter CanMaintenance Configurable Settings Options for Station SetupOptions for Pump Setup Troubleshooting General TroubleshootingStation Alarms Pump AlarmsWarranty Warranty SpecificationsWarranty Restrictions AppendixWarranty Liabilities Optional ComponentsCustomer Responsibilities Drawings and Diagrams Spare Parts ListController Identification Serial Number Tag Technical Assistance Contact Information