Sterling Plumbing 822.00247.00 specifications Initial System Setup Screen

Page 27

System Setup

To set the system settings and features of your conveying system, press the F6 key on the controller keypad while in the Main Menu screen. The initial (of three) System Setup screen will be shown (below):

Figure 13: Initial System Setup Screen

This screen will allow you to set the following features:

•INSTALLED HOPPERS – This will allow you to input the number of stations present in the system. Values can be entered between 0 and 9 total hoppers.

•HI VAC DEBOUNCE- This is the minimum amount of time (in seconds) that a High Vacuum Signal will occur before being recognized by the system. This value can be entered between 0.1 and 9.9.

•HI VAC DELAY- This is the amount of time (in seconds) before the High Vacuum Alarm will occur once a High Vacuum Signal has been recognized. This value can be set between 2.0 and 9.9.

Once the values have been entered for the settings listed above, the operator can choose to do the following:

•Turn the system On or Off (Press F1 while in this screen)

•Enter additional values for the system in the second setup screen (Press F3).

•Return to the Main Menu (Press F6).

1 –Pump 9-Station Controller

Chapter 3: Installation

26 of 38

Image 27

Contents SCC 1-Pump 9-Station Controller Parts and Service Department If the Shipment is Not Complete Shipping InformationUnpacking and Inspection Event of Shipping DamageWarranty Returns ReturnsCredit Returns Table of Contents Configurable Settings Safety How to Use This ManualSafety Symbols Used in this Manual Controller Safety Tags Description Wear Safety Glasses and Work Gloves General Responsibility ResponsibilityMaintenance Responsibility Reporting a Safety DefectOperator Responsibility Functional Description Models Covered in This ManualGeneral Description Controller Features Standard FeaturesMechanical Features Electrical FeaturesFail Safe Operation Optional FeaturesSafety Devices and Interlocks Safety Circuit StandardsSafety Device Lock-Outs Mounting the Control Panel InstallationMaking Control Panel Power Drop Wiring Connections UncratingConnecting the Control Panel to the Pump Package Connecting the Control Panel to Vacuum HoppersSetup Basic Menus and Setup of ControllerActivating and Deactivating the System Name Description Viewing System StatusInitial Station Setup Screen Station SetupController Keypad Entering Values Into Controller FieldsSecond Station Setup Screen Third Station Setup Screen Initial Pump Setup Screen Pump SetupSecond Pump Setup Screen Third Pump Setup Screen Initial System Setup Screen System SetupThird System Setup Screen Second System Setup ScreenStarting and Stopping the System AlarmsOperation OverviewFilter Can Pump FaultGeneral Fault All FaultsMaintenance Options for Station Setup Configurable SettingsOptions for Pump Setup General Troubleshooting TroubleshootingPump Alarms Station AlarmsAppendix WarrantyWarranty Specifications Warranty RestrictionsWarranty Liabilities Optional ComponentsCustomer Responsibilities Spare Parts List Drawings and DiagramsTechnical Assistance Contact Information Controller Identification Serial Number Tag