Appendix A - LCM Icon Overview
Appendix A - LCM Icon Overview
Icon | Label | Description | |
|
|
|
|
|
| Power On | When the corresponding soft key is pressed, the PR70 will exit disable mode |
|
|
| and enter the last mode used (Shot or manual) and display the corresponding |
|
|
| mode on the home run screen. |
|
|
|
|
|
| Shot Mode Designa- | Used on main home screen to indicate the machine is in shot mode. On the |
|
| tion | maintenance mode screen, it also indicates the user wants to either close or |
|
|
| open the machine dispense valve. |
|
|
|
|
|
| Operator Mode Des- | Used on main home screen to indicate the machine is in Manual mode. |
|
| ignation |
|
|
|
|
|
|
| Maintenance Mode | Used on main home screen to indicate the machine is in Maintenance mode. |
|
| Designation |
|
|
|
|
|
|
| Mode Select Desig- | When the corresponding soft key is pressed, the machine will enter a mode |
|
| nation | select run screen. |
|
|
|
|
|
| Setup Screen Desig- | When the corresponding soft key is pressed, the machine will enter the start of |
|
| nation | the setup screens for the machine. |
|
|
|
|
|
| Next Field Designa- | When the corresponding soft key is pressed, the user will navigate into a |
|
| tion | screen or to the next field within a screen. |
|
|
|
|
|
| Accept User Entry | When the corresponding soft key is pressed, the user accepts the value(s) or |
|
|
| options shown on the screen. |
|
|
|
|
|
| Abort User Entry | When the corresponding soft key is pressed, the user aborts the value(s) or |
|
|
| options shown on the screen. Activating this option will essentially allow the |
|
|
| user to go back one step in the programming or screen navigation sequence. |
|
|
|
|
|
| Stuck Key | Graphic used to indicate that the control has detected that one of the keys is |
|
| ||
|
|
| stuck in the ON position. |
|
|
|
|
|
|
|
|
|
| Bad Linear Sensor | Graphic used to indicate that the control has detected that readings from the |
|
|
| linear position sensor are invalid. |
|
|
|
|
|
| Improper Machine | Graphic used to indicate that the control has no or invalid readings for the |
|
| Calibration | extend, retract and metering tube positions. |
|
|
|
|
|
| Retract Position | Graphic used to indicate the full retract position of the pump. |
|
|
|
|
|
| Extend Position | Graphic used to indicate the full extend position of the pump. |
|
|
|
|
|
| Metering Tube | Graphic used to indicate the position on the pump where the piston first enters |
|
| Entrance Position | the pump metering tube. |
|
|
|
|
60 | 334135B |