4.Turn the stand assembly upright and attach the top, as shown in Figure 11, with (8)
x 8
Figure 11. Stand top attached.
5.Square up the stand components and fully tighten all the fasteners.
6.Place the level on top of the stand assembly, as shown in Figure 12, then adjust the feet up or down to make the stand top level from side to side and front to back. Make sure that both hex nuts on the feet are tight against the stand assembly.
7.With the help of other people, lift the bandsaw assembly onto the stand and align the mount- ing holes.
8.Secure the bandsaw assembly to the stand with (4) M8-1.25 x 35 hex bolts, (8) 8mm flat washers, (4) 8mm lock washers, and (4) M8-1.25 hex nuts, as shown in Figure 13.
x 4
Figure 13. Bandsaw assembly attached to the
stand.
9.Position the table trunnion on the bandsaw, as shown in Figure 14, then secure it with the
(2) M8-1.25 x 30 hex bolts and (2) 8mm lock washers.
Figure 12. Leveling the stand.
x 2 | Trunnion |