SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov- ice machine operator with a basic understanding of how the machine is used during operation, so the machine controls/components discussed later in this manual are easier to understand.
Due to the generic nature of this overview, it is not intended to be an instructional guide. To learn more about specific operations, read this entire manual and seek additional training from expe- rienced machine operators, and do additional research outside of this manual by reading "how- to" books, trade magazines, or websites.
To reduce the risk of serious injury when using this machine, read and understand this entire manual before operating.
Damage to your eyes and lungs could result from using this machine without proper pro- tective gear. Always wear safety glasses and a respirator when operating this machine.
To complete a typical operation, the operator does the following:
1.Examines the workpiece to make sure it is suitable for cutting.
2.Adjusts the fence for the width of the cut and then locks it in place.
3.Adjusts the table tilt, if necessary, to the cor- rect angle of the desired cut.
4.Loosens the guide post lock knob, adjusts the upper blade guide height to just clear the workpiece, then re- tightens the guide post lock knob.
5.Checks to make sure the workpiece can safe- ly pass all the way through the blade without interference from other objects.
6.Puts on safety glasses and a respirator.
7.Starts the dust collector and bandsaw.
8.Holds the workpiece firmly and flatly against both the table and fence, and then pushes the workpiece into the blade at a steady and controlled rate until the workpiece moves completely beyond the blade.
The operator is very careful to keep fingers away from the blade and uses a push stick to feed narrow workpieces.
9.Stops the bandsaw.
NOTICE
If you have never used this type of machine or equipment before, We strongly rec- ommend that you read books, review industry trade magazines, or get formal training before beginning any projects. Regardless of the content in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.
Model G0555/G0555P (Mfg. Since 5/11) |