Grizzly G0555 owner manual Assembly, Ing the stand easier in a later step

Assembly

Some metal parts may have sharp edges that can cause minor injury. Please exam- ine the edges of all metal parts BEFORE handling them and be careful WHILE handling them.

To assemble the bandsaw:

1.Lay one stand side flat on a protective sur- face, then attach the upper and lower stand braces, as shown in Figure 8, with (8) M6-1 x 16 hex bolts, (8) 6mm flat washers, and (8) M6-1 flange nuts.

Note: Only hand-tighten the stand fasteners for now during these initial steps. Once the stand is fully assembled you will be instructed to fully tighten all fasteners.

2.Attach the remaining stand side to the assem- bly, as shown in Figure 9, with (8) M6-1 x 16 hex bolts, (8) 6mm flat washers, and (8) M6-1 flange nuts.

Figure 9. Second stand side attached.

3. Install the foot assemblies into the holes in

the bottom of the stand assembly, using (2)

3⁄8"-16 hex nuts and (2) 10mm flat washers,

as shown in Figure 10.

Note: Adjust the feet so that they are approxi-

mately the same height—this will make level-

Upper

Stand Brace

Lower

Stand Brace

x 8

Stand Side

ing the stand easier in a later step.

x 4

Figure 8. Upper and lower stand braces

attached to the stand side.

Model G0555/G0555P (Mfg. Since 5/11)

Figure 10. Stand foot installed (1 of 4).

-17-