8.Unwind approximately 15" of filter paper and fold approximately 6" over one of the con- veyor ribs so when you push the manual feed button (Figure 29), the conveyor will draw the paper through the machine and into the recovery cabinet.
Note: For assistance, you can use a couple of pieces of tape to hold the filter paper on the conveyor.
Figure 29. Supply cabinet manual feed button.
9.Remove the five Phillips head screws and the recovery cabinet shroud (Figure 30).
Shroud
Figure 30. Recovery cabinet shroud.
10.Connect the machine to power, and push and hold the manual feed button while watching the progress of the filter paper as it passes through the machine.
11.When the filter paper just begins to enter at the top of the recovery cabinet, release the manual feed button and walk over to the recovery cabinet.
12.Remove the end of the filter paper from the conveyor, and then carefully pull the filter paper so approximately 15" of paper extends from the machine.
13.Place the end of the filter paper in the slot cut into the axle, and with your fingers, turn the axle toward you so you get a couple of wraps of paper on the roll (Figure 31).
Figure 31. Wrapping the recovery axle.
Make sure that the roll is wrapped in the directio where, when installed, the filter paper blocks the view of the roll, as seen through the window shown in Figure 26.
14.Position the recovery axle onto the spring- loaded spindle cone so that the slot in the axle engages with the drive tang on the spindle cone (Figure 32).
|
|
|
|
|
| Tang |
| Slot |
|
|
|
|
|
|
|
|
|
|
|