Woodstock W1730 manual Unpacking, Items Needed for Set Up, Description

Page 12

W1730 Oscillating Edge Sander

SET UP

SETUP

Unpacking

The SHOP FOX® Model W1730 has been carefully pack- aged for safe transporting. If you notice the machine has been damaged, please contact Woodstock International Technical Support at 1-360-734-3482 or send e-mail to: tech-support@shopfox.biz

Items Needed for Set Up

The following items are needed, but not included, to setup your machine:

Description
•	Phillips Screwdriver	1
•	Straight Slot Screwdriver	1
•	Machinist's Square	1
•	Hammer	1
•	Socket 7/8"	1
•	Ratchet w/6" extension	1
•	Hex Wrench 4mm	1
•	Dust Collector	1
•	Dust Hoses 4"	2
•	Hose Clamps 4"	4

READ and understand this entire instruc- tion manual before using this machine. Serious personal injury may occur if safety and operational information is not understood and followed. DO NOT risk your safety by not reading!

Seek assistance when lifting the machine from the shipping box . The Model W1730 weighs 396 lbs.

UNPLUG the power cord before you do any assembly or adjustment tasks! Otherwise, serious personal injury to you or others may occur!

-10-

Image 12

Contents Oscillating Edge Sander Page Table of Contents Introduction Woodstock Technical SupportAbout Your New W1730 Oscillating Edge Sander Controls and Features IntroductionSafety Standard Machinery Safety InstructionsSafety Additional Safety for Oscillating Edge Sanders Avoiding Potential Injuries Do not sand wood with fingers close To spindleElectrical Circuit RequirementsCircuit Type NemaGrounding Requirements Extension CordsSET UP Items Needed for Set UpUnpacking DescriptionBox Contents Figure InventoryMachine Placement Cleaning Machine To install the belt, do these steps Sanding BeltBackstop To mount the back stop, do these stepsDust Port Dust Port DoorDust Port Cover To install the sanding spindle, do these steps Sanding SpindleDust Collection Gear BoxTest Run To check and refill the gear box, do these stepsTo adjust the sanding belt tracking, do these steps Belt TrackingUnplug the sander If the belt is not tracking correctly, repeat StepsOperations GeneralBelt Grits Emergency Stop ButtonPlaten Angle Adjustment Table AdjustmentTo adjust the platen angle, do these steps To vertically adjust the table, do these stepsTo adjust the miter gauge, do these steps Miter GaugeFence Spindle Table HeightSpindle Sanding End & Edge SandingTo perform spindle sanding operations, do these steps To perform an edge or end sanding operation, do these stepsMaintenance CleaningTable & Base Lubrication To grease the rack and pinion gear, do these stepsSpindle Connector EccentricMaintenance Schedule Maintenance NotesEvery 6-8 Hours of Running Time Every 2,000 hoursCalibrating Angle Gauge To calibrate the angle gauge, do these stepsRemoving Drive Roller To remove the drive roller, do these stepsW1730 Wiring Diagram Troubleshooting Symptom Possible CauseDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Parts Breakdown DescriptionGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools