Woodstock W1730 manual Avoiding Potential Injuries, Do not sand wood with fingers close To spindle

Page 9

W1730 Oscillating Edge Sander

Avoiding Potential Injuries

SAFETY

Figure 2. DO NOT leave a gap between wood and back stop, and keep hands away from belt.

Figure 5. ALWAYS use the back stop, and keep

fingers away from the belt.

Figure 3. DO NOT sand wood with fingers close

to spindle.

Figure 6. ALWAYS keep your fingers away from

the spindle.

Figure 4. DO NOT sand wood with sharp corners at the leading-edge of the sanding operation.

The belt can grab and throw the wood.

-7-

Figure 7. ALWAYS sand wood with sharp corners at the trailing-edge of the sanding operation.

Image 9

Contents Oscillating Edge Sander Page Table of Contents Introduction Woodstock Technical SupportAbout Your New W1730 Oscillating Edge Sander Introduction Controls and FeaturesStandard Machinery Safety Instructions SafetySafety Additional Safety for Oscillating Edge Sanders Do not sand wood with fingers close To spindle Avoiding Potential InjuriesCircuit Requirements ElectricalCircuit Type NemaExtension Cords Grounding RequirementsItems Needed for Set Up SET UPUnpacking DescriptionInventory Box Contents FigureMachine Placement Cleaning Machine Sanding Belt To install the belt, do these stepsBackstop To mount the back stop, do these stepsDust Port Dust Port DoorDust Port Cover Sanding Spindle To install the sanding spindle, do these stepsGear Box Dust CollectionTest Run To check and refill the gear box, do these stepsBelt Tracking To adjust the sanding belt tracking, do these stepsUnplug the sander If the belt is not tracking correctly, repeat StepsGeneral OperationsBelt Grits Emergency Stop ButtonTable Adjustment Platen Angle AdjustmentTo adjust the platen angle, do these steps To vertically adjust the table, do these stepsMiter Gauge To adjust the miter gauge, do these stepsFence Spindle Table HeightEnd & Edge Sanding Spindle SandingTo perform spindle sanding operations, do these steps To perform an edge or end sanding operation, do these stepsMaintenance CleaningTable & Base To grease the rack and pinion gear, do these steps LubricationEccentric Spindle ConnectorMaintenance Notes Maintenance ScheduleEvery 6-8 Hours of Running Time Every 2,000 hoursTo calibrate the angle gauge, do these steps Calibrating Angle GaugeTo remove the drive roller, do these steps Removing Drive RollerW1730 Wiring Diagram Symptom Possible Cause TroubleshootingDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Description Parts BreakdownGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools