Woodstock W1730 manual Calibrating Angle Gauge, To calibrate the angle gauge, do these steps

Page 28

W1730 Oscillating Edge Sander

SERVICE

General

This section covers the most common service adjustments or procedures that may need to be made during the life of your machine.

If you require additional machine service not covered in this section, please contact Woodstock International Technical Support for additional guidance at (360) 734- 3482 or send e-mail to: tech-support@shopfox.biz.

Calibrating Angle Gauge

In order to maintain accuracy and precision with the oscil- lating edge sander, periodically calibrate the angle gauge.

To calibrate the angle gauge, do these steps:

1.Loosen the angle adjustment lock handle.

2.Place the machinist's square on the table and press it against the platen.

3.Adjust the platen until it is flush with the machinist's square as in Figure 37.

4.Tighten the angle adjustment lock handle.

5.Loosen the angle indicator pin screw, shown in Figure 38, a 1/2 turn.

6.Align the angle indicator pin with the 90˚ mark and tighten the angle indicator pin screw.

Make sure that your machine is unplugged during all service proce- dures! If this warning is ignored, seri- ous personal injury may occur.

Figure 37. Aligning table to platen.

SERVICE

Figure 38. Angle indicator pin screw.

-26-

Image 28

Contents Oscillating Edge Sander Page Table of Contents Woodstock Technical Support IntroductionAbout Your New W1730 Oscillating Edge Sander Controls and Features IntroductionSafety Standard Machinery Safety InstructionsSafety Additional Safety for Oscillating Edge Sanders Avoiding Potential Injuries Do not sand wood with fingers close To spindleElectrical Circuit RequirementsCircuit Type NemaGrounding Requirements Extension CordsSET UP Items Needed for Set UpUnpacking DescriptionBox Contents Figure InventoryMachine Placement Cleaning Machine To install the belt, do these steps Sanding BeltBackstop To mount the back stop, do these stepsDust Port Door Dust PortDust Port Cover To install the sanding spindle, do these steps Sanding SpindleDust Collection Gear BoxTest Run To check and refill the gear box, do these stepsTo adjust the sanding belt tracking, do these steps Belt TrackingUnplug the sander If the belt is not tracking correctly, repeat StepsOperations GeneralBelt Grits Emergency Stop ButtonPlaten Angle Adjustment Table AdjustmentTo adjust the platen angle, do these steps To vertically adjust the table, do these stepsTo adjust the miter gauge, do these steps Miter GaugeFence Spindle Table HeightSpindle Sanding End & Edge SandingTo perform spindle sanding operations, do these steps To perform an edge or end sanding operation, do these stepsCleaning MaintenanceTable & Base Lubrication To grease the rack and pinion gear, do these stepsSpindle Connector EccentricMaintenance Schedule Maintenance NotesEvery 6-8 Hours of Running Time Every 2,000 hoursCalibrating Angle Gauge To calibrate the angle gauge, do these stepsRemoving Drive Roller To remove the drive roller, do these stepsW1730 Wiring Diagram Troubleshooting Symptom Possible CauseDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Parts Breakdown DescriptionGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools