Woodstock W1730 manual Dust Port Door, Dust Port Cover

W1730 Oscillating Edge Sander

Dust Port

SETUP

To mount the dust port, do these steps:

1.Align the dust port holes with the tapped holes on the side of the sander.

2.Insert the 1/4-20 x 3/8 Phillips head screws with 1/4" washers, through the aligned holes and tighten as shown in Figure 14.

Dust Port Door

To mount the dust port door, do these steps:

1.Align the dust port door hinges with the hinges on the sander.

2.Insert the hinge pins through the aligned hinges, as shown in Figure 15, and tap with a hammer for full insertion.

3.Close and latch the dust port door.

Dust Port Cover

To mount the dust port cover, do these steps:

1.Align the dust port cover hinges with the hinges on the sander.

2.Insert the hinge pins through the aligned hinges (Figure 16), and tap with a hammer.

3.Shut and latch the dust port cover.

Figure 14. Dust port installation.

Figure 15. Dust port door.

Figure 16. Inserting dust port cover hinge

pin.

-14-