Woodstock W1730 manual Spindle Connector, Eccentric

Page 26

W1730 Oscillating Edge Sander

Spindle Connector

MAINTENANCE

The spindle connector connects the shafts from the motor to the gear box and is secured by two set screws that need to be tightened every time the gear box oil is filled (every 500 hours).

To secure the spindle connector set screws, do these steps:

1.Refer to Lubrication Steps 1-3 on Page 23 to remove the gear box cover

2.Tighten the set screws shown in Figure 35.

3.Reinstall the gear box cover.

Eccentric

The eccentric on the Model W1730 is connected to the shaft by a set screw. This set screw needs to be tightened every time the gear box oil is filled (every 500 hours).

To secure the eccentric set screw, do these steps:

1.Refer to Lubrication, Steps 1-3 on Page 23 to remove the gear box cover.

2.Tighten the set screw on the eccentric, shown in

Figure 36.

3.Reinstall the gear box cover.

Figure 35. Spindle connector set screws.

Figure 36. Eccentric set screw.

-24-

Image 26

Contents Oscillating Edge Sander Page Table of Contents About Your New W1730 Oscillating Edge Sander IntroductionWoodstock Technical Support Controls and Features IntroductionSafety Standard Machinery Safety InstructionsSafety Additional Safety for Oscillating Edge Sanders Avoiding Potential Injuries Do not sand wood with fingers close To spindleCircuit Type ElectricalCircuit Requirements NemaGrounding Requirements Extension CordsUnpacking SET UPItems Needed for Set Up DescriptionBox Contents Figure InventoryMachine Placement Cleaning Machine Backstop To install the belt, do these stepsSanding Belt To mount the back stop, do these stepsDust Port Cover Dust PortDust Port Door To install the sanding spindle, do these steps Sanding SpindleTest Run Dust CollectionGear Box To check and refill the gear box, do these stepsUnplug the sander To adjust the sanding belt tracking, do these stepsBelt Tracking If the belt is not tracking correctly, repeat StepsBelt Grits OperationsGeneral Emergency Stop ButtonTo adjust the platen angle, do these steps Platen Angle AdjustmentTable Adjustment To vertically adjust the table, do these stepsFence To adjust the miter gauge, do these stepsMiter Gauge Spindle Table HeightTo perform spindle sanding operations, do these steps Spindle SandingEnd & Edge Sanding To perform an edge or end sanding operation, do these stepsTable & Base MaintenanceCleaning Lubrication To grease the rack and pinion gear, do these stepsSpindle Connector EccentricEvery 6-8 Hours of Running Time Maintenance ScheduleMaintenance Notes Every 2,000 hoursCalibrating Angle Gauge To calibrate the angle gauge, do these stepsRemoving Drive Roller To remove the drive roller, do these stepsW1730 Wiring Diagram Troubleshooting Symptom Possible CauseDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Parts Breakdown DescriptionGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools