Woodstock W1730 manual Belt Tracking, To adjust the sanding belt tracking, do these steps

Page 19

W1730 Oscillating Edge Sander

Belt Tracking

After the sanding belt has been removed or replaced, or used for a significant amount of time, it may be necessary to adjust the sanding belt tracking.

To adjust the sanding belt tracking, do these steps:

1.Turn the machine ON long enough to observe the tracking of the sanding belt, then turn it OFF.

2.If the sanding belt does not track on a centered path across the rollers, adjustment is necessary.

3.Unplug the sander!

4.Loosen the jam nut shown in Figure 22.

5.Determine if the sanding belt is tracking too high, or too low:

If the belt tracks above center, turn the adjustment nut, shown in Figure 22, counterclockwise.

If the sanding belt tracks below center, turn the adjustment nut clockwise.

6.Tighten the jam nut.

7.Connect the machine to power and turn ON. Observe the belt tracking behavior for at least two minutes:

•­ If the belt is tracking correctly, no further adjustment is necessary.

•­ If the belt is not tracking correctly, repeat Steps 3-7.

Jam Nut

CW CCW

Adjustment

Nut

Figure 22. Jam and adjustment nuts, clockwise (CW) and Counter Clockwise (CCW) rotation.

DO NOT attempt to perform any adjustments to the sanding belt while the machine is connected to a power source. Failure to unplug before adjusting the sanding belt could result in serious personal injury.

SETUP

-17-

Image 19
Contents Oscillating Edge Sander Page Table of Contents Woodstock Technical Support IntroductionAbout Your New W1730 Oscillating Edge Sander Introduction Controls and FeaturesStandard Machinery Safety Instructions SafetySafety Additional Safety for Oscillating Edge Sanders Do not sand wood with fingers close To spindle Avoiding Potential InjuriesNema ElectricalCircuit Requirements Circuit TypeExtension Cords Grounding RequirementsDescription SET UPItems Needed for Set Up UnpackingInventory Box Contents FigureMachine Placement Cleaning Machine To mount the back stop, do these steps To install the belt, do these stepsSanding Belt BackstopDust Port Door Dust PortDust Port Cover Sanding Spindle To install the sanding spindle, do these stepsTo check and refill the gear box, do these steps Dust CollectionGear Box Test Run­ If the belt is not tracking correctly, repeat Steps To adjust the sanding belt tracking, do these stepsBelt Tracking Unplug the sanderEmergency Stop Button OperationsGeneral Belt GritsTo vertically adjust the table, do these steps Platen Angle AdjustmentTable Adjustment To adjust the platen angle, do these stepsSpindle Table Height To adjust the miter gauge, do these stepsMiter Gauge FenceTo perform an edge or end sanding operation, do these steps Spindle SandingEnd & Edge Sanding To perform spindle sanding operations, do these stepsCleaning MaintenanceTable & Base To grease the rack and pinion gear, do these steps LubricationEccentric Spindle ConnectorEvery 2,000 hours Maintenance ScheduleMaintenance Notes Every 6-8 Hours of Running TimeTo calibrate the angle gauge, do these steps Calibrating Angle GaugeTo remove the drive roller, do these steps Removing Drive RollerW1730 Wiring Diagram Symptom Possible Cause TroubleshootingDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Description Parts BreakdownGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools