Woodstock W1730 manual Controls and Features, Introduction

Page 5

W1730 Oscillating Edge Sander

Controls and Features

2	3	4	5
1
			6
16
			7
15
			8
14
13			9
13
12			10
12
			11

Figure 1. Controls and Features of the W1730.

1.	Sanding Spindle Table	9.	Belt Tracking Adjustment
2.	Sanding Spindle	10.	Vertical Adjustment Lock Handles
3.	Belt Access Door	11.	Vertical Adjustment Handwheel
4.	Emergency Stop Switch	12.	Storage Compartment
5.	Back Stop	13.	Sanding Table
6.	Dust Port	14.	ON/OFF Switch
7.	Motor	15.	Table Lock Levers
8.	Angle Adjustment & Lock Handle	16.	Spindle Table Adjustment Lock Handle

INTRODUCTION

For Your Own Safety Read Instruction Manual Before Operating Saw

a)Wear eye protection.

b)Support workpiece with miter gauge, backstop or worktable.

c)Maintain 1⁄16" in maximum clearance between table and sanding belt.

d)Avoid kickback by sanding in accordance with the directional arrows.

-3-

Image 5

Contents Oscillating Edge Sander Page Table of Contents About Your New W1730 Oscillating Edge Sander IntroductionWoodstock Technical Support Introduction Controls and FeaturesStandard Machinery Safety Instructions SafetySafety Additional Safety for Oscillating Edge Sanders Do not sand wood with fingers close To spindle Avoiding Potential InjuriesCircuit Requirements ElectricalCircuit Type NemaExtension Cords Grounding RequirementsItems Needed for Set Up SET UPUnpacking DescriptionInventory Box Contents FigureMachine Placement Cleaning Machine Sanding Belt To install the belt, do these stepsBackstop To mount the back stop, do these stepsDust Port Cover Dust PortDust Port Door Sanding Spindle To install the sanding spindle, do these stepsGear Box Dust CollectionTest Run To check and refill the gear box, do these stepsBelt Tracking To adjust the sanding belt tracking, do these stepsUnplug the sander If the belt is not tracking correctly, repeat StepsGeneral OperationsBelt Grits Emergency Stop ButtonTable Adjustment Platen Angle AdjustmentTo adjust the platen angle, do these steps To vertically adjust the table, do these stepsMiter Gauge To adjust the miter gauge, do these stepsFence Spindle Table HeightEnd & Edge Sanding Spindle SandingTo perform spindle sanding operations, do these steps To perform an edge or end sanding operation, do these stepsTable & Base MaintenanceCleaning To grease the rack and pinion gear, do these steps LubricationEccentric Spindle ConnectorMaintenance Notes Maintenance ScheduleEvery 6-8 Hours of Running Time Every 2,000 hoursTo calibrate the angle gauge, do these steps Calibrating Angle GaugeTo remove the drive roller, do these steps Removing Drive RollerW1730 Wiring Diagram Symptom Possible Cause TroubleshootingDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Description Parts BreakdownGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools