Woodstock W1730 manual Maintenance Schedule, Maintenance Notes, Every 6-8 Hours of Running Time

Page 27

W1730 Oscillating Edge Sander

Maintenance Schedule

•Every 2 Hours of Running Time: Clean and lubricate table top, miter slot and fence.

•Every 3 Hours of Running Time: Check belt tracking. Check sanding belt condition.

• Every 6-8 Hours of Running Time:	Replace belt.
• Every 2,000 hours:	Replace the rubber V-Belt (recommended). Check the
	eccentric and spindle connector. Lubricate all oil ports and
	grease fittings, rack and pinion gear, and check gear box.

Maintenance Notes

DATE

MAINTENANCE PERFORMED

MAINTENANCE

-25-

Image 27

Contents Oscillating Edge Sander Page Table of Contents Introduction Woodstock Technical SupportAbout Your New W1730 Oscillating Edge Sander Introduction Controls and FeaturesStandard Machinery Safety Instructions SafetySafety Additional Safety for Oscillating Edge Sanders Do not sand wood with fingers close To spindle Avoiding Potential InjuriesNema ElectricalCircuit Requirements Circuit TypeExtension Cords Grounding RequirementsDescription SET UPItems Needed for Set Up UnpackingInventory Box Contents FigureMachine Placement Cleaning Machine To mount the back stop, do these steps To install the belt, do these stepsSanding Belt BackstopDust Port Dust Port DoorDust Port Cover Sanding Spindle To install the sanding spindle, do these stepsTo check and refill the gear box, do these steps Dust CollectionGear Box Test Run If the belt is not tracking correctly, repeat Steps To adjust the sanding belt tracking, do these stepsBelt Tracking Unplug the sanderEmergency Stop Button OperationsGeneral Belt GritsTo vertically adjust the table, do these steps Platen Angle AdjustmentTable Adjustment To adjust the platen angle, do these stepsSpindle Table Height To adjust the miter gauge, do these stepsMiter Gauge FenceTo perform an edge or end sanding operation, do these steps Spindle SandingEnd & Edge Sanding To perform spindle sanding operations, do these stepsMaintenance CleaningTable & Base To grease the rack and pinion gear, do these steps LubricationEccentric Spindle ConnectorEvery 2,000 hours Maintenance ScheduleMaintenance Notes Every 6-8 Hours of Running TimeTo calibrate the angle gauge, do these steps Calibrating Angle GaugeTo remove the drive roller, do these steps Removing Drive RollerW1730 Wiring Diagram Symptom Possible Cause TroubleshootingDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Description Parts BreakdownGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools