Woodstock W1730 manual Removing Drive Roller, To remove the drive roller, do these steps

Page 29

W1730 Oscillating Edge Sander

Removing Drive Roller

The Model W1730 comes equipped with a puller to remove the drive roller should it ever become necessary to do so.

To remove the drive roller, do these steps:

1.Remove the hex nut and lock washer securing the driver roller to the shaft.

2.Thread the two 1/4-20 x 1-3/4 cap screws on the puller four turns into the threaded holes in the drive roller.

3.Thread and tighten the 5/16-18 x 1-1/4 cap screw into the puller, shown in Figure 39, until the drive roller is pulled.

4.To re-install, place the drive roller on the shaft, and thread the lock washer and hex nut onto the shaft and tighten securely. Note: Do not hammer the drive roller onto the shaft or you will cause damage to the shaft.

Figure 39. Using the drive roller puller.

SERVICE

-27-

Image 29
Contents Oscillating Edge Sander Page Table of Contents About Your New W1730 Oscillating Edge Sander IntroductionWoodstock Technical Support Introduction Controls and FeaturesStandard Machinery Safety Instructions SafetySafety Additional Safety for Oscillating Edge Sanders Do not sand wood with fingers close To spindle Avoiding Potential InjuriesCircuit Requirements ElectricalCircuit Type NemaExtension Cords Grounding RequirementsItems Needed for Set Up SET UPUnpacking DescriptionInventory Box Contents FigureMachine Placement Cleaning Machine Sanding Belt To install the belt, do these stepsBackstop To mount the back stop, do these stepsDust Port Cover Dust PortDust Port Door Sanding Spindle To install the sanding spindle, do these stepsGear Box Dust CollectionTest Run To check and refill the gear box, do these stepsBelt Tracking To adjust the sanding belt tracking, do these stepsUnplug the sander ­ If the belt is not tracking correctly, repeat StepsGeneral OperationsBelt Grits Emergency Stop ButtonTable Adjustment Platen Angle AdjustmentTo adjust the platen angle, do these steps To vertically adjust the table, do these stepsMiter Gauge To adjust the miter gauge, do these stepsFence Spindle Table HeightEnd & Edge Sanding Spindle SandingTo perform spindle sanding operations, do these steps To perform an edge or end sanding operation, do these stepsTable & Base MaintenanceCleaning To grease the rack and pinion gear, do these steps LubricationEccentric Spindle ConnectorMaintenance Notes Maintenance ScheduleEvery 6-8 Hours of Running Time Every 2,000 hoursTo calibrate the angle gauge, do these steps Calibrating Angle GaugeTo remove the drive roller, do these steps Removing Drive RollerW1730 Wiring Diagram Symptom Possible Cause TroubleshootingDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Description Parts BreakdownGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools