Woodstock W1730 manual Maintenance, Cleaning, Table & Base

Page 24

W1730 Oscillating Edge Sander

MAINTENANCE

General

Regular periodic maintenance on your SHOP FOX® Model W1730 will ensure its optimum performance. Make a habit of inspecting your oscillating edge sander each time you use it.

Check for the following conditions and repair or replace when necessary:

Loose mounting bolts.

Worn or damaged sanding belts.

Worn switch.

Worn or damaged cords and plugs.

Damaged V-belt.

Any other condition that could hamper the safe operation of this machine.

Make sure that your machine is unplugged during all maintenance pro- cedures! If this warning is ignored, seri- ous personal injury may occur.

MAINTENANCE

Cleaning

Frequently blow-off sawdust with compressed air. This is especially important for the internal working parts and motor. Dust build-up around the motor is a sure way to decrease its life span.

Occasionally it will become necessary to clean the internal parts with more than compressed air. To do this, remove the table top and clean the internal parts with a citrus cleaner or mineral spirits and a stiff wire brush or steel wool. Make sure the internal workings are dry before using the sander again, so that wood dust will not accumulate. If any essential lubrication is removed during cleaning, re-lubricate those areas.

Table & Base

Tables can be kept rust-free with regular applications of a product like SLIPIT®. For long term storage you may want to consider a product like Boeshield T-9™.

-22-

Image 24
Contents Oscillating Edge Sander Page Table of Contents Introduction Woodstock Technical SupportAbout Your New W1730 Oscillating Edge Sander Controls and Features IntroductionSafety Standard Machinery Safety InstructionsSafety Additional Safety for Oscillating Edge Sanders Avoiding Potential Injuries Do not sand wood with fingers close To spindleElectrical Circuit RequirementsCircuit Type NemaGrounding Requirements Extension CordsSET UP Items Needed for Set UpUnpacking DescriptionBox Contents Figure InventoryMachine Placement Cleaning Machine To install the belt, do these steps Sanding BeltBackstop To mount the back stop, do these stepsDust Port Dust Port DoorDust Port Cover To install the sanding spindle, do these steps Sanding SpindleDust Collection Gear BoxTest Run To check and refill the gear box, do these stepsTo adjust the sanding belt tracking, do these steps Belt TrackingUnplug the sander ­ If the belt is not tracking correctly, repeat StepsOperations GeneralBelt Grits Emergency Stop ButtonPlaten Angle Adjustment Table AdjustmentTo adjust the platen angle, do these steps To vertically adjust the table, do these stepsTo adjust the miter gauge, do these steps Miter GaugeFence Spindle Table HeightSpindle Sanding End & Edge SandingTo perform spindle sanding operations, do these steps To perform an edge or end sanding operation, do these stepsMaintenance CleaningTable & Base Lubrication To grease the rack and pinion gear, do these stepsSpindle Connector EccentricMaintenance Schedule Maintenance NotesEvery 6-8 Hours of Running Time Every 2,000 hoursCalibrating Angle Gauge To calibrate the angle gauge, do these stepsRemoving Drive Roller To remove the drive roller, do these stepsW1730 Wiring Diagram Troubleshooting Symptom Possible CauseDuring operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Parts Breakdown DescriptionGear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools