KitchenAid KBPU182VSS GAS Conversions, Tools and Parts for Gas Conversion, Phillips screwdriver

2.Remove packing from around burner.

3.Remove plastic bags from grate and film from cover.

4.Reinstall grate.

5.Dispose of/recycle all packaging materials.

6.Go to the “Check and Adjust the Burners” section.

Tools and Parts for Gas Conversion

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed

or 7 mm nut driver

Parts supplied

■Brass connector

■Convertible regulator 4" (10.2 cm) W.C. Natural, 11" (28 cm) W.C. LP

■Natural gas orifices

IMPORTANT: Gas conversions must be done by a qualified installer. Before proceeding with conversion, shut off the gas supply to the appliance prior to disconnecting the electrical power.

This kit is designed for use from sea level up to 2000 ft elevation. For higher elevations contact KitchenAid at 1-800-422-1230in the U.S.A. or call 1-800-607-6777in Canada.

WARNING

Explosion Hazard

Use a new CSA International approved “outdoor” gas supply line.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.