KitchenAid KBPU182VSS Change the Power burner orifices, Reinstall cap onto convertible regulator

6.Apply pipe sealant to the threads of the brass connector. Use pipe thread sealant that is certified for use with LP gas.

7.Use adjustable wrench to install brass connector (supplied) to manifold fitting.

NOTE: The arrow on the regulator must be pointing toward the brass connector.

8.Use pipe wrench to install the convertible regulator. Brass cap will be facing up when tight.

AB

A. Brass elbow

B. Convertible regulator

9.To make sure the regulator is set for Natural gas, use adjustable wrench to remove brass cap on appliance regulator.

10.Examine the stem on the brass cap. If the letters “NAT” are not showing on the end of the plastic stem farthest away from the brass cap, remove stem from cap, turn it over and snap stem back into the cap so the letters “NAT” are at the end of the stem farthest away from the brass cap.

NAT

11.Reinstall cap onto convertible regulator.

Change the Power™ burner orifices

1.Remove the Power™ burner grate.

2.Remove the wok ring. Twist counterclockwise, lift, and set aside.

3.Remove inner burner top ring from burner base.

4.Remove outer burner top ring from burner base.

A

B

C

A. Inner burner

B. Outer burner

C. Burner base

5.Remove the burner base.

a. Lift rear of burner to remove locator pin from locator hole.

A

b.Gently pull the burner base to the rear to disengage the burner from the gas valves and openings.

IMPORTANT: The igniter is connected to the burner base. Make sure the wires do not get pulled from the ignition.

c.Rotate burner base 90° and place in the bottom of the burner box.

A

A. Igniter wire

6.Use a 7 mm socket and wrench or 7 mm nut driver to remove the brass orifices from the gas valves.

A

B

A. Inner burner

B. Outer burner