KitchenAid KBPU182VSS Electrical Requirements, Gas Supply Requirements, Recommended Ground Method

Page 9

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

Check with a qualified electrician if you are not sure whether the Power™ burner is properly grounded.

A120-volt, 60-Hz, AC-only, 15-amp, fused electrical supply is required.

It is recommended that a separate circuit servicing only this Power™ burner be provided.

To avoid electrical shock, do not immerse cord or plugs in water or other liquid.

Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts.

Do not operate any outdoor cooking gas appliance with a damaged cord, damaged plug, or after the appliance malfunctions or has been damaged in any manner. Contact the manufacturer for repair.

Do not let the cord hang over the edge of a table or touch hot surfaces.

Do not use an outdoor cooking appliance for purposes other than intended.

When connecting, first connect plug to the outdoor cooking gas appliance then plug appliance into the outlet.

Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance.

Do not remove the ground prong or use with an adapter of 2 prongs.

The model/serial number rating plate is located on the right-hand side panel. See the following illustration.

A

A. Model/serial number plate

Recommended Ground Method

The outdoor Power™ burner, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code ANSI/NFPA 70, or Canadian Electrical Code, CSA C22.1.

Copies of the standards listed above may be obtained from:

CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575

National Fire Protection Association

One Batterymarch Park

Quincy, Massachusetts 02269

B

A

C

A. 3 prong ground plug

B. 3-prong polarized type outdoor GFI outlet

C. Ground prong

Gas Supply Requirements

WARNING

Explosion Hazard

Use a new CSA International approved “outdoor” gas supply line.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Observe all governing codes and ordinances.

IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1 - latest edition or CAN/CGA B149.1 - latest edition.

IMPORTANT: The Power™ burner must be connected to a regulated gas supply.

Refer to the model/serial rating plate for information on the type of gas that can be used. If this information does not agree with the type of gas available, check with your local gas supplier.

9

Image 9
Contents Outdoor BUILT-IN Power Burner Your safety and the safety of others are very important Outdoor BUILT-IN Power Burner SafetyQuincy, Massachusetts Cleveland, Ohio Important Safety InstructionsTable DES Matières Table of ContentsProduct Dimensions Installation RequirementsTools and Parts Location RequirementsMaker Ice Cabinet Dimensions= 3 7.6 cm Between a Trash Drawer, Utility Drawer, or Warming Drawer19³⁄₈ 49.2 cm 10¾ 27.3 cm 19¾ 50.2 cm 13½ 34.3 cm 10⁵⁄₈ 27.0 cm 22¹¹⁄₁₆ 57.6 cm30½ 77.5 cm 10¾ 27.3 cm 23 58.4 cm Built-in Outdoor Grill Enclosure Ventilation for LP GasElectrical Requirements Gas Supply RequirementsRecommended Ground Method Gas Connection Requirements Installation Instructions Install Tank Tray for 20 lb LP Gas Fuel TankNatural Gas Conversion Make Gas Connection Gas Connection to Natural Gas or Local LP Gas To Install the 20 lb LP Gas Fuel TankPlug in Power Burner Assemble Cooking AreaLift off cover and grate and set aside GAS Conversions Installation of the regulatorTools and Parts for Gas Conversion Conversion to a Local LP Gas SupplyMake Power Burner Connections Connect Local LP Gas Supply Conversion from LP Gas to Natural GasRecord Conversion Reinstall cap onto convertible regulator Change the Power burner orificesCheck and Adjust the Burners Low Flame AdjustmentHook up to Natural gas and Leak Test Power Burner Use Using Your Outdoor Power BurnerLighting Your Power Burner Manually lighting the Power burnerRemove the outdoor Power burner cover General Cleaning Outdoor Power Burner CareCleaning Method Do not soak knobsAssistance or Service TroubleshootingAccessories U.S.AKitchenaid Outdoor Product Warranty This limited warranty does not coverCall Page Votre sécurité et celle des autres est très importante Sécurité DU Brûleur Dextérieur Encastré PowerConservez CES Instructions Dimensions du produit Exigences DinstallationExigences demplacement Dimensions du placardPlan = 3 7,6 cm Dimension C Dimension D Dimension E19³⁄₈ 49,2 cm 10¾ 27,3 cm 19¾ 50,2 cm 13½ 34,3 cm 10⁵⁄₈ 27 cm 22¹¹⁄₁₆ 57,6 cm30½ 77,5 cm 10¾ 27,3 cm 23 58,4 cm Taille de la porte Dimension F Dimension LMéthode recommandée de mise à la terre Spécifications électriquesSpécifications de lalimentation en gaz Détendeur Exigences concernant le raccordement au gazBouteille de propane de 20 lb Puissance thermique des brûleurs en altitudeInstructions ’INSTALLATION Installation du brûleur dextérieur Encastré PowerConversion pour lalimentation au gaz naturel Installation du chariot de bouteille de gaz propane de 20 lb Installation de la bouteille de propane de 20 lb Raccordement de gazRaccordement à une bouteille de gaz propane de 20 lb Alimentation au gaz naturel ou au gaz propane local Branchement du brûleur PowerSoulever le couvercle et la grille et les mettre de côté Installation de la surface de cuissonConversions DE GAZ Installation du détendeurOutillage et pièces pour la conversion de gaz Conversion au gaz propane localEnregistrer la conversion Conversion du gaz propane au gaz naturelRemplacement des gicleurs du brûleur Power 11. Réinstaller le chapeau sur le détendeur convertibleEnlever la grille du brûleur Power 12. Réinstaller la grille de brûleur 10. Réinstaller le cerclage supérieur du brûleur interneContrôle et réglage des brûleurs Raccordement au gaz naturel et recherche de fuitesUtilisation du brûleur Power Utilisation DU Brûleur Power DextérieurAllumage du brûleur Power Allumage manuel du brûleur PowerPlacer le wok sur le cerclage de wok Nettoyage général Entretien DU Brûleur Power DextérieurMéthode de nettoyage Détergent doux, chiffon doux et eau tiède Rincer et sécherAccessoires Assistance OU ServiceDépannage Au CanadaGarantie DES Produits Pour Usage Extérieur Kitchenaid La présente garantie limitée ne couvre pasComposer le 1-800-422-1230. Au Canada, composer le Page All rights reserved W10243318B

KBPU182VSS specifications

The KitchenAid KBPU182VSS is a standout appliance that perfectly combines style and functionality for modern kitchens. This built-in refrigerator is designed to enhance the food storage experience, offering a range of features that cater to performance and aesthetics alike.

One of the most notable features of the KBPU182VSS is its spacious interior, with a capacity of 18 cubic feet, which allows ample room for groceries, leftovers, and culinary ingredients. The stainless steel finish adds a sleek and contemporary look, making it a perfect fit for various kitchen designs. This model seamlessly integrates into cabinetry, ensuring a polished and cohesive kitchen appearance.

The refrigerator is equipped with the advanced FreshSeal technology that helps to keep food fresher for longer. This is achieved through enhanced cooling capabilities that maintain consistent temperatures. The cooling system utilizes a dual evaporator, which is essential for optimal humidity control. This feature prevents odor mixing between the fridge and freezer, ensuring that everything—from meats to fruits—remains flavorful and fresh.

Organization is another key aspect of the KBPU182VSS. It features adjustable shelves that allow users to customize the interior layout according to their storage needs. The produce drawers are specifically designed to maintain ideal humidity levels for fruits and vegetables, prolonging their freshness. Additionally, the model comes with specialized storage for beverages, dairy, and other commonly used items, promoting convenience in access.

One innovative feature is the vibrant LED lighting that illuminates the interior, making it easy to find items quickly, even in low-light conditions. The door bins are designed for easy access and can accommodate larger bottles and containers, proving to be a practical solution for busy households.

The KitchenAid KBPU182VSS also boasts energy-efficient technology, reducing its environmental impact while keeping energy bills low. This is in line with KitchenAid's commitment to sustainability, giving customers peace of mind regarding their energy consumption.

In summary, the KitchenAid KBPU182VSS perfectly melds style, functionality, and technology, making it an excellent choice for anyone looking to upgrade their kitchen. Its thoughtful design features, advanced cooling technologies, and organization options set it apart in the competitive market of built-in refrigerators, satisfying both aesthetic and practical needs.