Graco 3A2495C important safety instructions See Clean the Gun Daily, Replacement, page 52

Troubleshooting

Problem	Cause	Solution
Voltage/current display stays red	Gun is too close to the part being	Gun should be 8–12 in. (200–300
(smart guns only).	sprayed.	mm) from the part.
	Check fluid resistivity.	See
		Check Fluid Resistivity, page 26.
	Dirty gun.	See Clean the Gun Daily, page 29.
ES or Hz indicator is amber.	Alternator speed is too low.	Increase air pressure until
		indicator is green. To avoid
		over-atomization, use the
		atomizing air restrictor valve to
		reduce the atomizing air to the air
		cap.
ES or Hz indicator is red.	Alternator speed is too high.	Decrease air pressure until
		indicator is green.
Error display appears and Hz	Smart module has lost	Check for good connections
indicator is red (Smart guns only).	communication with the power	between Smart Module and
	supply.	power supply. See Smart Module
		Replacement, page 52 and
		Power Supply Removal and
		Replacement, page 45.

38 3A2495C