Graco 312001R Getting Started, Unclogging Spray Tip, Triggering Gun, Aiming Gun

Page 14

Setup

Getting Started

Use a piece of scrap cardboard to practice these basic spraying techniques before you begin spray- ing the surface.

•Hold gun 12 in. (30 cm) from surface and aim straight at surface. Tilting gun to direct spray angle causes an uneven finish.

Unclogging Spray Tip

To avoid fluid splashback:

• Never pull gun trigger when arrow-shaped han-

dle is between SPRAY and UNCLOG positions.

12in.

(30 cm)

even finish

thick

uneven

finishti5585a

thin

• Tip must be pushed all the way into guard.

1.To UNCLOG tip obstruction, engage trigger lock.

•Flex wrist to keep gun pointed straight. Fanning gun to direct spray at angle causes uneven fin- ish.

even finish	thin	thick	thin

ti2036a

Triggering Gun

Pull trigger after starting stroke. Release trigger before end of stroke. Gun must be moving when trigger is pulled and released.

ti2037a

Aiming Gun

Aim tip of gun at bottom edge of previous stroke, overlapping each stroke by half.

ti2038a

ti8908a

2.Point arrow-shaped handle backward to UNCLOG position.

3.Aim gun at piece of scrap or cardboard.

ti9048a

4.Unlock trigger lock. Pull trig- ger to clear clog.

ti8909a

5.When obstruction is cleared, engage trigger lock and rotate arrow-shaped handle back to SPRAY position.

ti9049a

Point the arrow-shaped handle on the spray tip forward to SPRAY and backward to UNCLOG obstructions.

14

312001R

Image 14

Contents Model Models 262800, 262805, 261815Agnum ProX7 Model Series B Series DSpecifications PSIGrounding Fire and Explosion Hazard Skin Injection Hazard Burn Hazard Electric Shock HazardPressurized Aluminum Parts Hazard Moving Parts HazardFluid supply container follow local code Grounding and Electric RequirementsThermal Overload Component Identification ProX Sprayers OnlySG2/SG3 Operation Pressure Relief ProcedurePressure Control Knob Settings Trigger LockOil- or Water-based Materials SetupPrime and Flush Storage Fluid To spray water-based materials after sprayPrime Spraying Techniques Install Tip and Guard on GunAdjust Spray Pressure Preventing Excessive Tip WearTriggering Gun Getting StartedUnclogging Spray Tip Aiming GunSelecting Tip Hole Size Tip SelectionChoosing the Correct Tip Tip Hole SizeTip Fan Width 12 Part Mm from Surface Reversible Tip Selection ChartUnderstanding Tip Number Hole SizeRelieve pressure, Shutdown and CleaningPail Flushing Ti9745a Ti8908a Power Flush OpenStop triggering gun. Engage trigger lock Cleaning InstaClean Fluid Filter ProX Sprayers Only Cleaning GunLong Term Storage StorageShort Term Storage Stowing Sprayer Paint Hoses Maintenance and ServiceCaring for Sprayer TipsTroubleshooting Problem Cause SolutionProX7 and ProX9 Insert screw Read Pump does not prime sec Problem Cause Solution See Thermal Overload, Technical Data Magnum X5 Series D Magnum X7 Series CMagnum ProX7 Magnum ProX9 Series B Graco Standard Warranty For Graco Canada Customers