![](/images/new-backgrounds/1302335/30233521x1.webp)
Install Tip/Guard Assembly (if not installed)
Install Tip/Guard Assembly (if not installed)
Reversible Tip Selection Chart
MATERIALS
*Thin | Medium | Heavy |
Thin stains, | Enamels, solid | Heavy latex |
stains, thin latex |
|
Getting Started with Basic Techniques
Use a piece of scrap cardboard to practice these basic spraying techniques before you begin spraying the surface.
•Hold sprayer 10 in. (25 cm) from surface and aim straight at surface. Tilting sprayer to direct spray angle causes an uneven finish.
211, 411 | 213, 413 | 315, 515, 517 |
*Install
(25 cm)
10 in.
thick
even finish
uneven
finish
thin
ti1478
1.Engage trigger lock and put prime/relief valve UP to release pressure. Then remove Tip/Guard Assembly.
ti14994a
2.Install filter to Spray Tip/Guard Assembly (make sure filter is fully installed into sprayer). NOTE: Filter assem- bly is
ti14775a
NOTICE
Make sure filter is completely screwed into the Tip/Guard Assembly to avoid damage to the filter.
3.Screw Tip/Guard Assembly onto sprayer. Tighten retaining nut until completely engaged with sprayer.
•Flex wrist to keep sprayer pointed straight. Fanning sprayer to direct spray at angle causes uneven finish.
|
| even finish | thin | thick | thin | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NOTE: How fast you move the sprayer will affect spray application. If material is pulsating, you are moving too fast. If material drips, you are moving too slow. See Trouble- shooting, page 20.
Triggering Sprayer
Pull trigger after starting stroke. Release trigger before end of stroke. Sprayer must be moving when trigger is pulled and released.
Start Moving | Pull Trigger | Release Trigger |
NOTICE
The tip is a permanently attached to the Tip/Guard Assembly. Removal will result in damage.
Aiming Sprayer
Aim tip of sprayer at bottom edge of previous stroke, over- lapping each stroke by half.
ti14782a
3A0153E | 11 |