Graco 258865 Setup, Suction Tube Selection, Standard Suction Tube sprays ceilings and walls

Page 8

Setup

Use only water-based or oil-based (mineral spirit-type) materials with flash point greater than 100° F (38° C). Do not use materials which state “FLAMMABLE” on the packaging. For more information about your material, request MSDS from distributor or retailer.

Spraying certain materials may cause static build-up in the sprayer that can result in static shock to the user. If this occurs, first ensure the mate- rial has a flash point greater than 100° F (38° C) and does not state that it is FLAMMABLE anywhere on the package. If still feeling a static shock, the material likely contains a non-mineral spirits fluid such as, but not lim- ited to, xylene, toluene, or naphtha, which can build up static. Switch to an alternative material.

Use oil-based material outdoors or in a well-ventilated indoor area with a flow of fresh air.

Keep spray area well-ventilated. Keep a good supply of fresh air moving through the area.

NOTICE

Your sprayer is NOT compatible with harsh cleaners such as chlorine bleach. Using these cleaners will cause damage to the sprayer.

Suction Tube Selection

This sprayer comes with two different suction tubes.

Standard Suction Tube (sprays ceilings and walls):

When spraying walls, the inlet of the suction tube should be aimed at the front of the material cup.

Setup

When spraying ceilings, the inlet of the suction tube should be aimed at the back of the material cup (towards the trigger).

Specialized Suction Tube (sprays floors): When spraying floors, the inlet of the suction tube should be aimed at the front of the material cup (towards Spray Tip/Guard Assembly).

NOTE: If the sprayer is angled or tilted too far, the suction tube will lose contact with the material and the sprayer will stop spraying.

ti15511a

8

3A0153E

Page 7 Page 9
Image 8
Page 7 Page 9
Contents ProShot Cordless Paint Sprayer Table of Contents Fire and Explosion Hazard Battery Hazard Component Identification Fb FaPressure Relief Procedure Trigger LockPrime/Relief Valve Position Trigger Locked Trigger Unlocked Red ring is visibleSprayer Status Indicator Charging the BatteryCharger Status Indicator Lights Standard Suction Tube sprays ceilings and walls SetupSuction Tube Selection Sprayer Setup InstallationCleanup/Storage Spraying Stains or Clear Coats Fine-Finish OptimizerPriming Method page 18 and/or Inlet Valve MaterialsStarting a New Job or Refilling the Cup Aiming Sprayer Reversible Tip Selection ChartTriggering Sprayer Unclogging Spray Tip/Guard Assembly Keep spray area well-ventilated. Keep a good supply Shutdown and CleaningFlushing Sprayer Ti15425a Ti15491a Tips Cleaning Sprayer ExteriorStorage Replacement Parts and Kits Part DescriptionInstallation ProShot Repair KitOutlet Valve Fitting RemovalAlternate Priming Method Inlet Valve Cleaning Troubleshooting Problem Cause SolutionReplace tip. See Install Tip/Guard Assembly Spray Pattern Diagnostics Problem Cause SolutionSee Unclogging Tip/Guard Assembly, Spray pattern spits at Technical Data 258865 258859Graco Standard Warranty Graco Information
Top Page Image Contents