Charging the Battery
Charging the Battery
Batteries may leak, explode, cause burns or cause an explosion if mishandled.
Batteries are initially 50% charges to provide optimum battery life and require charging before first use. It takes approximately 45 minutes to charge a dead battery to 80%, at which point it can be used.It will take approxi- mately 75 minutes to fully charge a dead battery.
1.Slide battery into charger as shown (light will turn on within 5 seconds).
NOTE: Batteries can remain in the charger, which automatically switches to maintenance mode. It is not recommended to store the battery in the charger for longer than one week.
To reduce the risk of electric shock, only use Graco batteries with the Graco charger. Do not insert any foreign objects into the adapter cup.
NOTE: The amount sprayed with each battery varies depending on material, tip size, battery charge, and bat- tery temperature. 1 battery fully charged will spray approximately 1 gallon when using the 515 tip with latex paint. You will get less when using a smaller tip or thin- ner material.
NOTE: The charger supplied with model 258859 comes with a power cord adapter connected to the power cord. To switch from the AS3112 connector to the
NOTICE
Do not place a wet battery in the charger. Damage to equipment will occur.
Charger Status Indicator Lights
| Label | Appearance | Description | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Solid green light | Indicates a full charge. Use the battery or leave it in the charger. |
|
|
|
|
|
|
| The automatic Maintenance Mode holds the batteries at full charge. | |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Flashing green light | Battery is charging, indicates 80% charge. |
|
|
|
|
|
|
| Battery can be used. | |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Flashing red light | Battery is charging, indicates less than 80% charge. |
|
|
|
|
|
|
| Do NOT use battery. | |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Solid red light | Battery is too hot or too cold to charge and must cool down or warm up |
|
|
|
|
|
|
| before charging. Leave battery in charger. | |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
Sprayer Status Indicator
Light | Appearance | Description |
| No light | Normal operation. |
| Solid red | Battery is low on power and needs to be charged, or battery |
|
| is too cold and must warm up before spraying. |
| Flashing red | Battery temperature is too high, or tip is clogged. |
|
| See Troubleshooting, page 20. |
NOTE: The indicator light is only visible when sprayer trigger is engaged. You must squeeze and hold the trigger to see the Sprayer Status Indicator.
3A0153E | 7 |