Graco 258859, 258865 important safety instructions Storage, Cleaning Sprayer Exterior, Tips

Page 15

Storage

Cleaning Sprayer Exterior

•Wipe paint off outside of sprayer using a soft cloth moistened with water or flushing fluid.

Do NOT submerge the sprayer.

Tips

•Tips will require replacement depending on abrasiveness of paint.

•Do not spray with worn tip. See Troubleshooting, page 20.

Storage

3.Reverse spray tip to UNCLOG position, put prime/relief valve DOWN to spray position, and aim sprayer into waste area. Pull trigger for 1-2 seconds.

4.Properly dispose of used Pump Armor mixture from material cup and rinse cup with water.

NOTICE

Failure to store with sprayer with Pump Armor will result in operational problems the next time you spray. Always circulate Pump Armor through the sprayer after cleaning. Water left in the sprayer will corrode and damage the pump.

1.Dilute 4 oz. bottle of Pump Armor Concentrate with an additional 4 oz. of water in material cup.

4oz

2.Thread cup into sprayer, put prime/relief valve to UP position and squeeze sprayer trigger for approxi- mately 10 seconds.

5.Store sprayer indoors in a cool, dry place. Store in an upright position only.

NOTE: For prolonged battery life, lithium batteries should be stored at half charge in an environment below 90° F (32° C).

3A0153E

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents ProShot Cordless Paint Sprayer Table of Contents Fire and Explosion Hazard Battery Hazard Fb Fa Component IdentificationTrigger Locked Trigger Unlocked Red ring is visible Pressure Relief ProcedureTrigger Lock Prime/Relief Valve PositionCharging the Battery Charger Status Indicator LightsSprayer Status Indicator Setup Suction Tube SelectionStandard Suction Tube sprays ceilings and walls Spraying Stains or Clear Coats Fine-Finish Optimizer Sprayer SetupInstallation Cleanup/StorageMaterials Starting a New Job or Refilling the CupPriming Method page 18 and/or Inlet Valve Reversible Tip Selection Chart Triggering SprayerAiming Sprayer Unclogging Spray Tip/Guard Assembly Shutdown and Cleaning Flushing SprayerKeep spray area well-ventilated. Keep a good supply Ti15425a Ti15491a Cleaning Sprayer Exterior StorageTips Part Description Replacement Parts and KitsRemoval InstallationProShot Repair Kit Outlet Valve FittingAlternate Priming Method Inlet Valve Cleaning Problem Cause Solution TroubleshootingSpray Pattern Diagnostics Problem Cause Solution See Unclogging Tip/Guard Assembly,Replace tip. See Install Tip/Guard Assembly Spray pattern spits at 258865 258859 Technical DataGraco Information Graco Standard Warranty
Top Page Image Contents