Spraying Stains or Clear Coats Fine-Finish Optimizer

Setup

Spraying Stains or Clear Coats (Fine-Finish Optimizer)

The Fine-Finish Optimizer should be installed and used when spraying thin material such as stain or clear coats. The Fine-Finish Optimizer restricts the material flow resulting in a finer quality finish.

Installation

1. Remove material cup and suction tube.

2.Push Fine-Finish Optimizer into pump inlet until completely engaged and re-install suction tube.

2.Put prime/relief valve to UP position, then hold trig- ger in for 10 seconds.

ti14999a

3. Put prime/relief valve DOWN to spray position.

4.Reverse spray tip to UNCLOG position and trigger sprayer into a waste area.

5.Engage trigger lock and put prime/relief valve UP to release pressure.

Cleanup/Storage

Be sure to remove and clean the Fine-Finish Optimizer immediately after use. Store the Fine-Finish Optimizer on the Storage/cleaning Tool supplied to keep the hole clear of dried material.

ti14994a

ti14999a

6.Unscrew and remove material cup.

7.Disengage trigger lock, put prime/relief valve DOWN, hold sprayer slightly above material cup, and pull trigger to discharge fluid from pump.

Sprayer Setup

This sprayer arrives from the factory with a small amount of test material in the system. It is important that you flush this material from the sprayer before using it for the first time:

1. Fill material cup with water and thread onto sprayer.

ti14992a

ti15478a

8. Discard material in cup.

3A0153E