Graco Inc 313869B, TI14427A, TI14428A Mount Gun, Reciprocating Arm Rod Mount, Stationary Support

Page 12

Installation

Mount Gun

Reciprocating Arm Rod Mount

To mount the gun on a reciprocating arm rod [0.75 in. (19 mm) diameter maximum], insert the bar (A) through the hole in the manifold as shown in FIG. 3.

NOTE: Use the 1/8 in. alignment slot (P) to assist in orienting the gun.

Secure the gun to the bar by tightening the mounting screw (B).

		A
B
	P	TI14433A

FIG. 3: Reciprocating Arm Mount

Stationary Support

To mount the gun on a stationary support, refer to FIG. 4 and to the correct mounting hole lay- out for your gun, page 30 - 31.

C

Guns with manifold

C

TI14434A

1.Align the gun or manifold with the align- ment pins. Locate alignment slot and holes per the mounting hole layout.

2.Secure the gun to the support with two M8 x 1.25 capscrews (C). The screws must be long enough to engage the threaded holes to a depth of 1/4 in. (6 mm).

TI14435A

Guns without manifold

FIG. 4: Stationary Support Mount

12

313869B

Image 12

Contents Important Safety Instructions AirPro EFX Automatic Spray GunContents ModelsFire and Explosion Hazard Equipment Misuse Hazard Toxic Fluid or Fumes Hazard Selection Charts Gun SelectionProper Needle/Nozzle Selection Models With Manifolds Models Without ManifoldsNeedle Assembly Identification Air CapsSample Pattern Sizes and Shapes 313869B Installation Ventilate Spray BoothConfigure Gun and Manifold Guns with ManifoldGround System Guns without ManifoldMount Gun Reciprocating Arm Rod MountStationary Support Setup Connect Air LineAir regulator Connect Fluid Hose With ManifoldWithout Manifold Flush Spray Gun Adjust Spray Pattern Perform Pressure Relief Procedure,Position Air Cap Vertical Pattern Horizontal PatternSuggested Starting Settings Spray Fan Air Atomizing Air Fluid Pressure RegulatorPressure Relief Procedure OperationApply Fluid IncorrectDaily Gun Care General System Maintenance Clean and Flush GunFollow the Pressure Relief Procedure, 313869B Troubleshooting WrongProblem Cause Solution Service DisassemblyReassembly Parts Guns with ManifoldGuns without Manifold Parts in Common Additional Parts for Models with ManifoldAccessories Repair KitsDimensions Mounting Hole Layouts 44.7 mm M8 x 1.25 T 35 in .9 mm deep 24.1 mm Slot Technical Data Triggering SpeedSound Data ConventionalHiTEch Air BrushAir Flow Spray Pattern Test Report Spray Pattern Test ReportGraco Standard Warranty Graco Information