Graco Inc TI14427A, 313869B, TI14428A important safety instructions Setup, Connect Air Line

Page 13

Setup

Connect Air Line

NOTE:

•If your regulated air source does not have a filter, install an air filter (G) on each air line to ensure a dry, clean air supply to the gun. Dirt and moisture can ruin the appearance of your finished workpiece. See FIG. 5.

•You must install a separate air pressure regulator (F) on the CYL, FAN, and ATOM air lines to control air pressure to the gun. See FIG. 6 and FIG. 7.

•Install a bleed type air shutoff valve (E) on each gun air supply line, down- stream of the gun air regulator, to shut off air to the gun.

Setup

1.The gun cylinder, fan, and atomization air must be supplied and regulated separately. To regulate air remotely, use solenoids (see FIG. 6 and FIG. 7).

NOTE: The three air inlet fittings accept 6 mm OD tubing.

2.Connect each air hose (D) to a regulated air supply line (H).

H

G	F E D ti01990a

FIG. 5: Connect Air Line

313869B

13

Image 13

Contents AirPro EFX Automatic Spray Gun Important Safety InstructionsModels ContentsFire and Explosion Hazard Equipment Misuse Hazard Toxic Fluid or Fumes Hazard Gun Selection Selection ChartsProper Needle/Nozzle Selection Models Without Manifolds Models With ManifoldsAir Caps Needle Assembly IdentificationSample Pattern Sizes and Shapes 313869B Ventilate Spray Booth InstallationConfigure Gun and Manifold Guns with ManifoldGuns without Manifold Ground SystemReciprocating Arm Rod Mount Mount GunStationary Support Connect Air Line SetupAir regulator With Manifold Connect Fluid HoseWithout Manifold Perform Pressure Relief Procedure, Flush Spray Gun Adjust Spray PatternPosition Air Cap Vertical Pattern Horizontal PatternFluid Pressure Regulator Suggested Starting Settings Spray Fan Air Atomizing AirOperation Pressure Relief ProcedureApply Fluid IncorrectDaily Gun Care Clean and Flush Gun General System MaintenanceFollow the Pressure Relief Procedure, 313869B Wrong TroubleshootingProblem Cause Solution Disassembly ServiceReassembly Guns with Manifold PartsGuns without Manifold Additional Parts for Models with Manifold Parts in CommonRepair Kits AccessoriesDimensions Mounting Hole Layouts 44.7 mm M8 x 1.25 T 35 in .9 mm deep 24.1 mm Slot Triggering Speed Technical DataConventional Sound DataHiTEch Air BrushAir Flow Spray Pattern Test Report Spray Pattern Test ReportGraco Information Graco Standard Warranty