Graco Inc 313869B, TI14427A, TI14428A important safety instructions Fire and Explosion Hazard

Page 3

Warnings

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this equip- ment. The exclamation point symbol alerts you to a general warning and the hazard symbol refers to procedure-specific risk. Refer back to these warnings. Additional, product-specific warnings may be found throughout the body of this manual where applicable.

WARNING

FIRE AND EXPLOSION HAZARD

Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent fire and explosion:

Use equipment only in well ventilated area.

Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and plastic drop cloths (potential static arc).

Keep work area free of debris, including solvent, rags and gasoline.

Do not plug or unplug power cords, or turn power or light switches on or off when flammable fumes are present.

Ground all equipment in the work area. See Grounding instructions.

Use only grounded hoses.

Hold gun firmly to side of grounded pail when triggering into pail.

If there is static sparking or you feel a shock, stop operation immediately. Do not use equipment until you identify and correct the problem.

Keep a working fire extinguisher in the work area.

313869B

3

Image 3
Contents AirPro EFX Automatic Spray Gun Important Safety InstructionsModels ContentsFire and Explosion Hazard Equipment Misuse Hazard Toxic Fluid or Fumes Hazard Selection Charts Gun SelectionProper Needle/Nozzle Selection Models Without Manifolds Models With ManifoldsNeedle Assembly Identification Air CapsSample Pattern Sizes and Shapes 313869B Guns with Manifold InstallationVentilate Spray Booth Configure Gun and ManifoldGuns without Manifold Ground SystemMount Gun Reciprocating Arm Rod MountStationary Support Connect Air Line SetupAir regulator Connect Fluid Hose With ManifoldWithout Manifold Vertical Pattern Horizontal Pattern Flush Spray Gun Adjust Spray PatternPerform Pressure Relief Procedure, Position Air CapFluid Pressure Regulator Suggested Starting Settings Spray Fan Air Atomizing AirIncorrect Pressure Relief ProcedureOperation Apply FluidDaily Gun Care General System Maintenance Clean and Flush GunFollow the Pressure Relief Procedure, 313869B Wrong TroubleshootingProblem Cause Solution Disassembly ServiceReassembly Parts Guns with ManifoldGuns without Manifold Additional Parts for Models with Manifold Parts in CommonRepair Kits AccessoriesDimensions Mounting Hole Layouts 44.7 mm M8 x 1.25 T 35 in .9 mm deep 24.1 mm Slot Triggering Speed Technical DataAir Brush Sound DataConventional HiTEchAir Flow Spray Pattern Test Report Spray Pattern Test ReportGraco Information Graco Standard Warranty