Graco Inc 313869B, TI14427A, TI14428A important safety instructions Mounting Hole Layouts

Page 30

Mounting Hole Layouts

Mounting Hole Layouts

Guns with Manifold

0.95 in

(24.1 mm)

1.4 in

(35.6 mm)

0.43 in.			3 x M8 x 1.25
0.43 in.
(10.9 mm)

0.86 in.

(21.8 mm)

ti14441a

1.22 in.

(31.0 mm)

FIG. 22

1.27 in

(32.3 mm)

ti14700a

0.34in. (8.6 mm) thru

0.13in. (3.3 mm) slot

30

313869B

Image 30

Contents Important Safety Instructions AirPro EFX Automatic Spray GunContents ModelsFire and Explosion Hazard Equipment Misuse Hazard Toxic Fluid or Fumes Hazard Selection Charts Gun SelectionProper Needle/Nozzle Selection Models With Manifolds Models Without ManifoldsNeedle Assembly Identification Air CapsSample Pattern Sizes and Shapes 313869B Configure Gun and Manifold InstallationVentilate Spray Booth Guns with ManifoldGround System Guns without ManifoldMount Gun Reciprocating Arm Rod MountStationary Support Setup Connect Air LineAir regulator Connect Fluid Hose With ManifoldWithout Manifold Position Air Cap Flush Spray Gun Adjust Spray PatternPerform Pressure Relief Procedure, Vertical Pattern Horizontal PatternSuggested Starting Settings Spray Fan Air Atomizing Air Fluid Pressure RegulatorApply Fluid Pressure Relief ProcedureOperation IncorrectDaily Gun Care General System Maintenance Clean and Flush GunFollow the Pressure Relief Procedure, 313869B Troubleshooting WrongProblem Cause Solution Service DisassemblyReassembly Parts Guns with ManifoldGuns without Manifold Parts in Common Additional Parts for Models with ManifoldAccessories Repair KitsDimensions Mounting Hole Layouts 44.7 mm M8 x 1.25 T 35 in .9 mm deep 24.1 mm Slot Technical Data Triggering SpeedHiTEch Sound DataConventional Air BrushAir Flow Spray Pattern Test Report Spray Pattern Test ReportGraco Standard Warranty Graco Information