Bosch Power Tools DUH Read All Instructions Before Using the Appliance, Operation

Page 3

IMPORTANT SAFETY INSTRUCTIONS

Read All Instructions Before Using the Appliance.

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

A.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.

B.Before servicing or cleaning the unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

C.Installation Work and Electrical Wiring Must Be Done By Qualified Person(s) In Accordance With All Applicable Codes & Standards, Including Fire-rated Construction.

D.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back- drafting. Follow the heating equipment manufacturers guideline and safety standards such as those published by the National Fire Protection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

E.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

F.Ducted systems must always be vented to the outdoors.

WARNING

CAUTION

FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPORS.

CAUTION

To reduce risk of fire and to properly exhaust air, be sure to duct air outside - do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces, or garages.

WARNING

TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT WORK.

Install this hood in accordance with all requirements specified.

WARNING

To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Hood With Any External Solid State Speed Control Device.

OPERATION

a.Always leave safety grills and filters in place. Without these components, operating blowers could catch onto hair, fingers and loose clothing.

The manufacturer declines all responsibility in the event of failure to observe the instructions given here for installation, maintenance and suitable use of the product. The manufacturer further declines all responsibility for injury due to negligence and the warranty of the unit automatically expires due to improper maintenance.

This unit is manufactured for indoor use only. Do not use this unit outdoors.

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Bosch ventilation installation manual DUH Models Page Read All Instructions Before Using the Appliance To Reduce the Risk of FIRE, USE only Metal Duct WorkOperation Electrical requirements Tools required Installing the HoodParts Included with your Hood Parts Not Included with your HoodRecirculating Vertical discharge Horizontal discharge Choose vent options Vent Exhaust OptionVertical discharge Horizontal dischargeTotal of both columns= After having choosen the vent option, proceed as follows Ductwork Installation GuidelinesPivot Top/back edge Exhaust transition/damper Recirculating Mark holesOutside top exhaust Outside rear exhaustChoose Venting Option 120 VAC, 15 or 20 Amp circuit requiredFailure to do so can result in death or electrical shock Page Avertissement AvertissementModeopératoire Spécifications électriques Lire Toutes les Instructions Avant d’Utiliser l’AppareilOutils nécessaires Installation DE LA HotteÉléments compris avec votre hotte Éléments non compris avec votre hotteÉvacuation verticale Évacuation horizontaleRecyclage d’air Évacuation verticale Évacuation horizontale 10 po Étape Après avoir choisi le type d’évacuation, procéderPivot Top/backArrière de la hotte edge Recyclage d’air Étape Emplacement des trousÉvacuation extérieure par le dessus de la hotte Évacuation extérieure par l’arrière de la hotteÉtape Étape finale d’installation RaccorderlahotteaucircuitélectriqueInstructions Pour LE Raccordement À LA Terre Leer LAS Instrucciones Antes DEL USO Advertencia AdvertenciaFuncionamiento Requisitos eléctricos Leer Todas las Instrucciones Antes de Usar el AparatoSe requieren 16 pasos para la instalación Instalar LA CampanaPartes Incluidas con la Campana Herramientas necesarias Partes no incluidas con la campanaRecirculación Descarga Vertical Descarga Horizontal Escoger las opciones de descarga de los gases de combustiónDescarga vertical Descarga horizontalTotal de ambas columnas= ¡ Atención Re-instalar la transición redonda con sus tornillos Marcar los orificios Extractor superior exteriorExtractor posterior exterior Instrucciones DE Conexión Eléctrica Escoger la Opción de Descarga10.Sólo para gabinetes ahuecados AdvertenciascableadocampanaLI2WVB
Top Page Image Contents