Bosch Power Tools DUH installation manual Pivot Top/back edge Exhaust transition/damper

Page 9

6.For rectangular ducted discharge installations only (otherwise skip to next step)

Attach exhaust adaptor/damper over knockout opening with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back edge of hood. Remove tape from damper flap.

Pivot

Top/back edge

Exhaust transition/damper

NOTE: The exhaust adaptor/damper can be installed up to 1 inch on either side of the hood center to accommodate off-center ductwork. In extreme off-center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

7.For round ducted discharge installations only Re-install the round transition with its screws.

7" Round

Transition

NOTE: The round transition can be installed up to 1 inch on either side of the hood center to accommodate off-center ductwork. In extreme off- center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

Image 9

Contents Bosch ventilation installation manual DUH Models Page Read All Instructions Before Using the Appliance To Reduce the Risk of FIRE, USE only Metal Duct WorkOperation Electrical requirements Parts Included with your Hood Installing the HoodParts Not Included with your Hood Tools requiredVertical discharge Choose vent options Vent Exhaust OptionHorizontal discharge Recirculating Vertical discharge Horizontal dischargeTotal of both columns= After having choosen the vent option, proceed as follows Ductwork Installation GuidelinesPivot Top/back edge Exhaust transition/damper Outside top exhaust Mark holesOutside rear exhaust RecirculatingChoose Venting Option 120 VAC, 15 or 20 Amp circuit requiredFailure to do so can result in death or electrical shock Page Avertissement AvertissementModeopératoire Spécifications électriques Lire Toutes les Instructions Avant d’Utiliser l’AppareilÉléments compris avec votre hotte Installation DE LA HotteÉléments non compris avec votre hotte Outils nécessairesÉvacuation verticale Évacuation horizontaleRecyclage d’air Évacuation verticale Évacuation horizontale 10 po Étape Après avoir choisi le type d’évacuation, procéderPivot Top/backArrière de la hotte edge Évacuation extérieure par le dessus de la hotte Étape Emplacement des trousÉvacuation extérieure par l’arrière de la hotte Recyclage d’airÉtape Étape finale d’installation RaccorderlahotteaucircuitélectriqueInstructions Pour LE Raccordement À LA Terre Leer LAS Instrucciones Antes DEL USO Advertencia AdvertenciaFuncionamiento Requisitos eléctricos Leer Todas las Instrucciones Antes de Usar el AparatoPartes Incluidas con la Campana Herramientas necesarias Instalar LA CampanaPartes no incluidas con la campana Se requieren 16 pasos para la instalaciónDescarga vertical Escoger las opciones de descarga de los gases de combustiónDescarga horizontal Recirculación Descarga Vertical Descarga HorizontalTotal de ambas columnas= ¡ Atención Re-instalar la transición redonda con sus tornillos Marcar los orificios Extractor superior exteriorExtractor posterior exterior 10.Sólo para gabinetes ahuecados Escoger la Opción de DescargaAdvertenciascableadocampana Instrucciones DE Conexión EléctricaLI2WVB