BM 1619P01046
Masonry Cutting Wheel Assembly
For cutting masonry materials like brick, tile, stone, etc., it is best to use a dry diamond cutting wheel. Use only lock nut and flange with equal diameters.
!WARNING Do not use water or other cooling fluid with this tool for
cutting.
!WARNING When using an abrasive cut- off wheel, be sure to use only
the special wheel guard designed for use with
Disconnect tool from power source before attaching cutting wheel. With cut off wheel guard (optional accessory) in place, assemble flange, cutting wheel and lock nut.
When cutting, make only small passes through workpiece at a time. Be aware that “Kickback” can occur at any time. Keep both hands on tool for maximum control.
SPINDLE
CUT OFF
WHEEL GUARD
BACKING FLANGE
DRY DIAMOND |
WHEEL |
LOCK NUT
Sanding Accessories Assembly
BACKING PAD
!WARNING Before attaching a backing pad be sure its maximum safe
operating speed is not exceeded by the nameplate speed of the tool.
Wheel guard may not be used for most sanding operations.
Always reinstall wheel guard when converting back to grinding operations.
TO INSTALL BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Set the tool on its top side (spindle up). Place the rubber backing pad onto the spindle shaft. Center the sanding disc on top of the backing pad. Insert the lock nut through the disc and thread onto the spindle as far as you can with your fingers. Press in the spindle lock, then tighten the backing pad securely with lock nut wrench.
TO REMOVE BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Using the lock nut wrench unscrew the nut from the spindle, while holding spindle lock in.
WIRE BRUSH ASSEMBLY
Before assembling wire brush to this tool, disconnect from the power source. Wire brushes are equipped with their own threaded hub, simply thread on to spindle. Be sure to seat against shoulder before turning tool “ON”.
SPINDLE |
BACKING |
PAD |
SANDING
DISC
LOCK NUT
WIRE
BRUSH