Bosch Power Tools 11250VSRD Installing Dust Canister, Changing the Microfilter, Port, Depth Gauge

BM 1619P02168 12-07 12/5/07 3:52 PM Page 9

INSTALLING DUST CANISTER

To install dust canister, push canister upward into the dust extraction system until you hear it lock into place (Fig. 6).

CHANGING THE MICROFILTER

For maximum efficiency, the microfilter should be replaced after approx. 15 hours of operation.

Remove the dust canister from the dust extraction system (Fig. 6).

Lift the microfilter upward and remove old or damaged filter from dust canister (Fig. 7).

Insert a new microfilter into the dust canister and reinstall the dust canister (Fig. 7.)

Note: If the microfilter is damaged (e.g. holes, damage to the soft sealing material), it must be replaced immediately. Working with a damaged microfilter can cause damage to the power tool.

Also replace the microfilter when the vacuuming performance is insufficient, even when the dust canister is empty.

FIG. 7

MICROFILTER

DUST

CANISTER

VACUUM ADAPTER DUST CANISTER (Not included, available as accessory)

For dust extraction with a vacuum cleaner, the (optional) vacuum adapter dust canister can be inserted into the dust extraction system instead of the dust canister, if required.

			hha
				m
		chh		aa
	ssc		h
o
B

Press the two canister release buttons and pull canister downward and remove from the dust extraction system (Fig. 6).

Install vacuum adapter dust canister upward
into dust extraction system until you hear it lock			VACUUM
into place (Fig. 8).			ADAPTER DUST
To use this feature, attach vacuum hose			CANISTER
(optional accessory) to dust port, then connect
opposite end of the vacuum hose to a shop
vacuum cleaner. A vacuum hose adapter		DUST	VACUUM
(optional accessory) is available for connecting	FIG. 8	PORT	HOSE
this tool to a 1-1/4" or 1-1/2" vacuum hose (Fig. 8).

The vacuum cleaner must be suitable for the material being drilled.

DEPTH GAUGE

Your drilling depth X can be pre-set and/or repeated by using the depth gauge.

After the auxiliary handle is installed, make sure the accessory has been fully inserted into the chuck before setting the depth gauge.

Set the depth gauge by compressing the telescopic guide toward the tool. When the desired length of the bit is exposed, press and slide the depth stop button against the guide housing and release the button (Fig. 9). The depth gauge is spring loaded and will return to the fully extended position when pressure has

-9-