Sears 206801, 113 Sliding GUA RD, Outfeedtable, Infeed Depth of CUT Handwheel, Slide Bracket

i! ! /,

1,

		2
	;E	SLIDING GUA RD
FENCE	OUTFEEDTABLE	/KNOB

INFEED

TABLE

SLIDE
8RACKET
	\		\
	,\\
4	CUTTER GUARD 6 ON-OFF		DEPTH OF CUT
	SWITCH		HANDWHEEL
	i	,,	i i1,1
	INFEED	_	DEPTH OF CUT
	TABLE	/ /J	HANDWHEEL
DEPTH OF CUT HANDWHEEL.	Turning the
handwheel counterclockwise will lower the infeed
table to maximum depth Of !/8,.in,

DOWN

2_

FENCE LOCKS AND STOPS. The fence can be moved acrossthe Jointer to take full advantage of the "sharpness" of the blades.

The fence should be positioned to the extreme right (toward pulley) but not beyond the end of the blades.

Most of the cutting [usually jointing) will be done with

the fence in this position. As the blades become dull, the fence can be moved toward the left where the

blades are sharper,

To move the fence, loosen the Fence Lock Knob and the Sliding Guard Knob and slide to desired position.

Make sure SLIDE BRACKET is even with surface of OUTFEE D TABLE. tf it is above or below the surface, loosen screws and adjust it,

a, Always tighten fence lock knob first to align fence, then tighten s_iding guard knob.

SLIDING GUARD KNOB

PUSH DOWN

WHEN LOCKING

FENCE LOCK KNOB

FENCE

45°FENCE

STOP

90 ° FENCE STOP

FENCE	LOCK
KNOB	\ \

12

SLIDE BRACKET