parts, find the following
18x 3/4 x2
7 Washers; 11/32 ID
7 Hex Jam NUts, 5/16-18
2 Cord Clips
2.Loosen FENCE LOCK KNOB. Tilt fence upward and slide J_toward the pulley.
3.Position machine on Leg Set and align mounting holes
m machine with holes in Leg Set letter coded "'A".
Mount with three (3)
4.Place a flat washer, a lock washer and a nut on each
screw from underneath the stand and tighten.
5.Place handwhee] on shaft aligning flat surfaces on shaft
with flat surfaces on handwheel _.. attach with
114-20 TRUSS SIDE STIFFENER
HEAD SCREW
/
o o |
| !B | B | / ...._o | o | o |
°_A |
| END | STIFFENER |
| o | |
0 | o_ |
| : | : _ _ A | o 0 |
|
...... |
|
| _o_.D- | |||
MOTOR | SUPPORT AT | THIS | END |
|
| |
_ JONTERfPLANER
_HEX | HEAD SCREW |
FLATWASHER--- STFFENER
LOCK WAS H E
HEXNUT
FENCE LOCK
KNOB
I
I
I
I
DEPTH OF CUT
_DWHEEL
CHECKING-CUTTER: BLADES AND SCREWS
TOOLS NEEDED
5/32" and t/8" Setscrew Wrenches (furnished with Jointer).
Lead Pencil
Short straight edge (or head of combination square)
1.tnsert pencil in space at end of cutterhead to hold cutterhead guard open.
2.Lower the infeed table with the Depth of Cut Handwheel.
3.Rest the straight edge on edge on the surface of outfeed
table so it extends across the opening between the
tables, at three positions: near each end and at the middle of the cutter blade.
4.Rotate the cutterhead by grasping the 2" alia. driven pulley and make sure each knife nicks (touches) the
straight | edge | at a ! three | post on:s | tf not f0 | ow |
p ocedure | unde | REPLAC | NG CUTTER | BLADES | on |
ppg. 21 | and | 22. |
|
|
|
| 5/32 IN. SETSCREW |
OUTFEED TABLE | WRENCH |
WEDGE
BLADE
PENCI L
CUTTER GUARD
5.If a cutter blade adjustment _s not required, check each
locking screw of each wedge 15/32" setscrew wrench)
and tighten if necessary, Hold the pulley while
tightening screws and be careful that your f'ngers do not slip off the wrench,"