Sears 113, 206801 Counter Clockwise, Infeed, Place Guard Tang Spring Center, Pivot PIN, Liftfence

INSTALLINGCUTTERGUARD SPRING

1.Remove cotter pin from pivot pin in cutter guard and

remove guard (located underneath infeed table.)

Spring must appear as in sketch from underside of in-

feed table, it will not perform properly if installed upside down.

2.Position guard as shown, with PIVOT PIN above hole in infeed table.

3.Align SLOT in pin with TANG in spring, and press down.

4.Replace cotter pin.

INFEED

/

FLATWASHER <_'- SPRING f

suPPORT/

\ >'"-__,IpLATE / _ _. --_ _ _

WASHER_ ___ /</_\ _<

//_'_, BUSHING _-_ _._'_

VIEW LOOKING UP

FENCE		/	/
	CUTTER	/
IN PLACE	GUARD	jr	, /

TANG OF	SPRING	_-T-'_._"j_._		' J
IN CENTER	OF	_.	_-----"'_	_
HOLE_
_.....INFEED		-	\_
"-""-TABLE			PIVOT	PIN

_-_TANG

LIFTFENCE

5. RAISE end of FENCE, rotate guard COUNTER clockwise only enough to CLEAR fence.

6.LOWER fence and tighten both knobs.

COUNTER

CLOCKWISE

23