to know your
e.: Adjust 45 ° stop in the same manner,
NOTE: Tilt scale will not require adjustment if it was adjusted for 90 ° position.
4.CUTTER GUARD, Provides protection over the cutter head. It must always be in place and function- ing properly.
Check the guard to make sure it is functioning pro- perI¥.
a.Position fence to right for maximum width of cut.
b.Pass a 1/4 in, thick piece of wood over cutterhead between quard and fence,
Guard must return automatically to="rest position'" against: fence when free of: the wood.
If gt_ard:does not return automatically, see Trouble
Shooting and Maintenance Sections.
i i
_. INFEEDTABLE:MUST ALWAYS BE PARAL- LEL TO THE OUTFEED TABLE,
If the cut edge or Surface of the workpiece is
CROWNED, it is an indication that the OUTWARD
END of the tNFEED table is HIGH and must be adjusted.
If the cut edge or surface of the workpiece is CON-
CAVE, it is an indication that the OUTWARD END of the INFEED table is LOW and must be adjusted,
Check the infeed table to determine the "out of
parallel" condition.
HEAD
OFINFEED
SQUARETABLE
FENCE
\
/
/CUTTER GUARD
CUTTER
GUARD
CROWNED CUT
INFEED TABLE
END HIGH
CONCAVE CUT
14