iNSTALLING | SLIDING GUARD | ||
PARTS NEEDED |
| ||
I | Sliding | Guard | _ |
1 | Sliding | Guard | Knob |
1 | Sliding | Guard | Rod |
2 | Sliding | Guard Washers (one side of washer is concave) | |
1 | Hex. | Nut 1/2 | in. _ 13 |
i :
1/2 IN. HEX NUT
tSpait toc'kwasher I/2 in.
2 Ext, tooth tockwashers
2
1.Screw nut all the way onto long end of rod . . . place 1/2 in. Iockwasher next to nut.
2.Screw rod alt the way into Jointer with short end up...
tighten nut.
3, Attach sliding guard to fence with two machine screws and Iockwashers.
4.Place one Sliding Guard Washer, concave side DOWN on support rod,
5, Drop sliding guard onto rod.., place other washer, con- cave side UP on rod . . . screw on Sliding Guard Knob.
SLI DIt'_'GGUARD
SLIDING GUARD KNOB
EXT. TOOTH
LOCKWASHERS
ii | ii lul ii | i | ill | i,u,nu, u,,,, |
WASH E R
(CONCAVE SIDE UP)
MOUNTING SWITCH
PARTSNEEDED
1 On!Off Power Outlet
2 Pan Hd. Screws,
2 Lockwashers, External 1/4
2 Washers, 17/64 x 1/2 x 1/32
MOUNTING RECOMMENDED CRAFTSMAN MOTOR AND BELT GUARDS
Seepage5 for recommendedmotors.
PARTS NEEDED
4 carriage bolts,
1 Jointer Planer Belt Guard
1 Motor Pulley Belt Guard
I Belt Guard Support
!Belt Guard Support Bracket
i | ii | i,,pl |
t. Place motor on your workbench with 6/8 in. dia. shaft (with key way) facing you.
2. Attach guard support to bracket with two screws.
NOTE: The holes in the bracket are not threaded, but the screws are "thread cutting screws" and will cut a thread as they are tightened.
Attach On/Off outlet to infeed table using two tapped holes.
3 Belt Guard Clips
1 Motor Pulley, 2q/2 in. dia.
1
2Pan Head Screws 10- 32 x I/2 in,
2Hex, Hd. Screws 1/4 - 20 x t/2 in,
2Hex. Nuts t/4- 20
TOOLS NEEDED
Medium Screwdriver
5/32 in, Setscrew Wrench (furnished with Jointer) t/2 and 7/t6 in. Wrenches
5/8 IN. DIA. SHAFT
PAN HD. SCREWS
BELT GUARD
SUPPORT
BRACKET
BELT GUARD
SUPPORT