23.Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for which it was not designed. The right tool will do the job better and safer.
24.Use recommended accessories; improper accessories may be hazardous.
25.Maintain tools with care. Keep knives sharp and clean for the best and safest performance. Follow instructions for lubricating and changing accessories.
26.Turn off the machine before cleaning. Use a brush or compressed air to remove chips or debris — do not use your hands.
27.Do not stand on the machine. Serious injury could occur if the machine tips over.
28.Never leave the machine running unattended. Turn the power off and do not leave the machine until it comes to a complete stop.
29.Remove loose items and unnecessary work pieces from the area before starting the machine.
30.When working a piece of wood on the jointer, follow the
31.Always use a
32.Do not joint material shorter than 10”, narrower than 3/4” or less than 1/4” thick.
33.Do not make cuts deeper than 3/4” when rabbeting. On other cuts such as edging, surfacing, etc., depth of cut should not be over 1/16” to avoid overloading the machine and to minimize chance of kickback.
34.Never apply pressure to stock directly over the cutterhead. This may result in the stock tipping into the cutterhead along with the operator’s fingers. Never back the workpiece toward the infeed table.
35.Don’t use in dangerous environment, don’t use jointer in damp or wet locations, or expose it to rain. Keep work area well lighted.
36.Always keep cutterhead and drive guards in place and in proper operation.
37.Always use
38.Maintain the proper relationships of infeed and outfeed table surfaces and cutterhead knife path.
39.Support the workpiece adequately at all times during operation; maintain control of the work at all times.
40.Don’t back the work toward the infeed table.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible machine damage.
This means that if precautions are not heeded, it may result in serious injury or possibly even death.
- - SAVE THESE INSTRUCTIONS - -
6